Product Specifications - Lincoln A Serie Bedienungsanleitung

Model 1410, 1410E,
Battery Charger
Important Charging Notes
1. Longest life and best performance can be
obtained if the battery pack is charged when
the air temperature is between 65°F and 75°F
(18° - 24°C). DO NOT charge the battery
pack in an air temperature below +32°F (0°C)
or above 105°F (+40.5°C). This is important
and will prevent serious damage to the bat-
tery pack.
2. The charger and battery pack may become
warm to the touch while charging. This is
a normal condition, and does not indicate a
problem.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging
in a lamp or other appliance.
b. Check to see if the receptacle is con-
nected to a light switch which turns power
off when you turn out the lights.
c. Move charger and battery pack to a loca-
tion where the surrounding air tempera-
ture is approximately 65°F - 75°F
(18 - 24°C).
d. If charging problems persist, take the
tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when
it fails to produce sufficient power on jobs
which were easily done previously. DO NOT
CONTINUE to use under these conditions.
Follow the charging procedure. You may
also charge a partially used pack whenever
you desire with no adverse affect on the bat-
tery pack.
5. Under certain conditions, with the charger
plugged into the power supply, the exposed
charging contacts inside the charger can be
shorted by foreign material. Foreign materi-
als of a conductive nature such as, but not
limited to, steel wool, aluminum foil, or any
buildup of metallic particles should be kept
away from charger cavities. Always unplug
the charger from the power supply when
there is no battery pack in the cavity. Un-
plug charger before attempting to clean.
6. Do not freeze or immerse charger in water
or any other liquid.
Page Number - 2
Don't allow any liquid to get inside charger.
Electric shock may result. To facilitate the
cooling of the battery pack after use, avoid
placing the charger or battery pack in a warm
environment such as a metal shed or an
uninsulated trailer.
Never attempt to open the battery pack for
any reason. If the plastic housing of the bat-
tery pack breaks or cracks, return to a service
center for recycling.

Product Specifications

Model 1410
Input Voltage 120 VAC/50-60 Hz
@ 2 amps
Output 14.4-18 VDC Volts
@ 2.8 Amps
Time to Charge
1401 Battery: 1 Hour Approx.
Cord Length6 ft (2 m)
Indicator Lights Red
Weight 2.2 lb. (1.01 Kg)
1410 or 1410E
Battery Charger
Model 1410E
230 VAC/50 Hz
@ 2 amps
14.4-18 VDC Volts
@ 2.8 Amps
1 Hour Approx.
6 ft (2 m)
Red
2.2 lb. (1.01 Kg)
1401/1801
(1401 Battery
shown)
Form 404391