Plug & Play (Initial Setup) - Samsung 5 Serie Handbuch

When the TV is initially powered on, a sequence of on-screen prompts will assist in coniguring basic settings.
Press the POWERP button. Plug & Play is available only when the Source is set to TV.
✎
Before turning on the TV, make sure the antenna cable is connected (p. 6).
1
Selecting a language Press the ▲ or ▼ button, then press the ENTERE button.
2
Setting the Network
3
Selecting Store
Demo or Home Use
4
Selecting a country
5
Setting the Clock
Mode
6
Selecting an antenna Press the ▲ or ▼ button, then press the ENTERE button. Select the Antenna
7
Selecting a channel
8
Complete
If You Want to Reset This Feature...
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0".
If you want to change the PIN number, use the Change PIN function.
You should do Plug & Play
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode,
which resets the PIN to "0-0-0-0":
Plug & Play (Initial Setup)
Select the desired OSD (On Screen Display) language.
Set up your network connection. Press the ENTERE button
to start. If you want to setting to it later, select Skip. For more
information, refer to "Wired/Wireless Network Connection" in the
e-Manual.
Press the ◄ or ► button, then press the ENTERE button.
Select the Home Use mode. Store Demo mode is for retail environments.
To return the unit's settings from Store Demo to Home Use (standard): Press the
volume button on the TV. When you see the volume OSD, press and hold
for 5 sec.
Store Demo is only for shop display. If you select it, several functions are not able
to use. Please select Home Use when you watch at home.
Press the ▲ or ▼ button, then press the ENTERE button. Select the
appropriate country.
✎
After selecting the country in the Country menu, some models may proceed
with an additional option to setup the pin number.
✎
When you input the PIN number, "0-0-0-0" is not available.
✎
The option may differ depending on country.
Set the Clock Mode automatically or manually.
Auto: Select the time zone where you are located.
Manual: Allows you to manually set the current date and time.
source. The option may differ depending on country.
Press the ▲ or ▼ button, then press the ENTERE button. Select the channel
source to memorise. When setting the antenna source to Cable, a step appears
allowing you to assign numerical values (channel frequencies) to the channels. For
more information, refer to Channel → Memorising Channels.
✎
When Air or Cable is selected first: After all Air or Cable channels are
stored, the step for storing Satellite channels is displayed.
✎
When Satellite is selected first: After all Satellite channels are stored, the
step for storing Air or Cable channels is displayed.
✎
Press the ENTERE button at any time to interrupt the memorisation
process.
Press the ENTERE button.
→ System) again at home although you did in shop.
(MENU
(off) →
POWER
English - 7
→ 8 → 2 → 4 →
MUTE POWER
POWER
P
MENU
(on).