Technical Data - EINHELL NEW GENERATION NAT 14 Gebrauchsanweisung

Anleitung NAT 14_SPK1:Anleitung NAT 14_SPK1
GB
responsible for any damage caused to third
persons by use of the trimmer.
Never cross roads or pebble paths with the grass
trimmer switched on.
When you are not using the grass trimmer, keep
it in a dry place out of the reach of children.
Use the grass trimmer only as described in these
directions for use and always hold it vertical to
the ground. All other positions are dangerous.
Check the screws regularly to see that they are
properly tightened.
Keep cables and other objects out of the area
you want to cut.
If you have to lift the grass trimmer to move it,
switch off the motor and wait for the rotating tool
to stop.
Before you connect the grass trimmer to the
power supply, make sure that none of its moving
parts are damaged and that the line spool is
correctly inserted and fastened.
Never cut against hard objects when using the
grass trimmer. This is imperative to avoid causing
injury to the user and damage to the trimmer.
Use only original replacement parts for repair and
maintenance purposes.
Examine the grass trimmer for signs of wear or
damage each time before you use it and after
any collisions. Have essential repairs carried out
without delay.
Always keep your hands and feet away from the
cutting mechanism, particularly when you switch
on the trimmer.
After pulling out new line, always return the
trimmer to normal working position before you
switch it on again.
Never use replacement parts or accessories
which are not foreseen or recommended by the
manufacturer.
Unplug the rechargeable battery before checking,
cleaning or doing any work on the machine and
when it is not being used.
Caution! The nylon line will run on for a few
seconds after the tool is switched off!
14
24.10.2006 7:51 Uhr Seite 14
3. Explanation of the warning notice
(see Figure 4) on the grass trimmer
1: Caution!
2: Wear safety goggles!
3: Protect from the damp!
4: Read the directions for use before putting into
operation for the first time!
5: Keep third parties away from the danger zone!
6: The tool runs on after being switched off!

4. Technical data

Speed n :
0
Cutting range:
Max. running period:
Nylon cutting line Ø
Type of protection:
Sound power level L :
WA
Sound pressure level L :
pA
Replaceable NC battery:
Front handle vibration a :
hv
Rear handle vibration a :
hv
Power supply unit:
Mains voltage:
Output:
Rated voltage:
Rated current:
The noise level of this machine may exceed 85
dB(A). In this case, noise protection measures need
to be introduced for the user. The machineʼs noise
was measured in accordance with prEN ISO 10518.
The level of vibrations emitted from the handle is <
2,5 m/s 2 . Measurements were taken in accordance
with prEN ISO 10518.
8500 min -1
25 cm diameter
approx. 25 min
1,2 mm
III
94 dB(A)
78 dB(A)
14,4 V d.c.
3.71 m/s 2
5.73 m/s 2
230 V ~ 50 Hz
18 V d.c.
400 mA