Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
Route the cables along the cable-management arm and secure the cables to
the cable-management arm with the Velcro straps attached to the cable-
management arm.
Make sure that the cables are not pinched in the cable-management arm joints.
For details on connecting the cables to the computer, see the Installation and
Troubleshooting Guide.
4.
Press the safety release latches on the inner-slide rails and slide the switch into
the rack until it snaps into place.
Be sure that the surfaces of the manifold and the switch are flush.
5.
Tighten the thumbscrew on the cable-management arm.
The thumbscrew passes through the hole in the rack and into the middle hole of
the adjustable bracket.
% &
To replace the rack's front and back doors, perform the following steps.
#
!
"
1.
Lift the front door into position, and align the hinges with the holes in the rack
(see Figure 1-3).
2.
Slide the hinges into the holes in the rack until the hinge release levers lock the
hinges into position.
3.
Close the door latch by rotating the handle counterclockwise until it stops, push
the handle in until it locks in position, and then slide the push-button cover down
over the push button (see Figure 1-2).
Repeat steps 1 through 3 to install the back door.
Rack Installation Guide
1-9
Werbung
