Mac allister MWDV16L Anleitungs- Und Sicherheitshandbuch Seite 9

VACUUMING DRY MATERIALS
In order to ensure proper filtering when vacuuming dust and dry materials, a foam sleeve and a
dust collection bag should be installed. If the vacuum was used to vacuum up liquids, the foam
sleeve must be cleaned and dried before using it to vacuum up dust.
NOTE: NEVER USE A VACUUM WITHOUT THE FILTER!
INSTALLATION AND CLEANING
Foam Sleeve
WARNING : Always ensure that the plug is disconnected from power source, the tool is switched
off before making any adjustments or maintenance procedures. Once the motor assembly is
upside down, slide the foam sleeve down over the cage. Keep sliding it down until it completely
covers the cage.
The foam sleeve should be cleaned regularly as described in the following steps:
1. Unplug the power cord from the electrical outlet before removing the motor assembly. Turn
the motor assembly over. Slide the foam sleeve toward the top of the cage to remove.
2. Shake the foam sleeve up and down quickly.
3. Submerge the foam sleeve in water for one or two minutes, then rinse it from the inside out.
Systematic cleaning with water is not necessary, it depends on the condition of the foam
sleeve.
4. Gently wring out the water, wipe it with a clean cloth, and let it dry. The foam sleeve is now
ready to be reinstalled over the cage.
DUST COLLECTION BAG
Fine dust, such as dust from cement, soot and plaster are too fine to be used with only the foam
sleeve and risk getting into the motor and damaging it, thereby, nullifying the vacuum cleaner's
guarantee. Therefore always use a dust collection bag when cleaning these types of materials.
1. Unplug the vacuum from the electrical outlet and remove the motor assembly from the tank.
2. Hold the cardboard collar tightly and slide the rubber protective element as far as possible onto
the intake port.
3. When everything is in place, unfold the bag out and position it around the inside walls of the
tank.
VACUUMING UP WATER AND LIQUIDS
Remove all dirt and debris from the tank. A foam sleeve must be used to vacuum up wet debris.
• Unplug the power cord from the wall outlet before removing the motor assembly from
the tank. Turn the motor over.
16L 1100W WET/DRY VACUUM CLEANER
EN
8