Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Recycling And Disposal - Mac allister MWDV16L Anleitungs- Und Sicherheitshandbuch

16l 1100w wet/dry vacuum cleaner
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 48
tank for an extended period of time. Clean the foam sleeve in order to avoid clogging from debris.
Never use water or chemical cleaning products with detergent to clean the vacuum cleaner. Use a
dry cloth. If the supply cord needs replacing, the task must be carried out by the manufacturer, the
manufacturer's agent, or an authorised service centre in order to avoid a safety hazard.

Troubleshooting

PROBLEM
Missing Parts/Accessories
The vacuum cleaner does
not start
Dust coming out of the
exhaust port
Loss of suction
Static Shock
Mist in exhaust air

Recycling and disposal

Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local Authority or local store for recycling
advice.
16L 1100W WET/DRY VACUUM CLEANER
POSSIBLE CAUSES
1. They are wrapped up in
the tank.
1. No power at the outlet.
2. Not plugged in correctly.
3. The power cord is cut.
4. On/Off switch defective.
5. Defective Motor.
1. The filter is not installed
or not installed correctly.
2. The filter is damaged.
3. The filter is clogged or
the dust is too fine.
4. The filter doesn't work.
1. The flexible hose fitting
is loose.
2. Filter clogged.
3. Tank or bag full.
4. Hole in the hose.
5. Hose or accessory
clogged.
1. Dry environment.
2. Air's relative humidity
too low.
1. The filter is saturated.
SOLUTIONS
1. Check the tank.
1. Check the power.
2. Unplug/insert the plug
into the outlet again.
3. Have it replaced by an
Authorised Customer
Service Center.
4. Have it repaired by an
Authorised Customer
Service Center.
5. Have it repaired by an
Authorised Customer
Service Center.
1. Install the filter correctly.
2. Replace the filter.
3. Use a more efficient filter.
4. Clean or replace the filter.
1. Tighten the fitting.
2. Clean or replace the filter.
3. Empty or replace them.
4. Replace the hose.
5. Check and unclog as
necessary.
1. Increase humidity. (Where
possible, use a portable or
stationary humidifier.)
2. This is temporary and does
not affect the use of
the vacuum cleaner.
1. Clean or replace the filter.
EN
10

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis