Hama 183283 Bedienungsanleitung Seite 4

Note
• Ensure that the mounting surface
to which the adhesive pad is to
attach (such as the back of a mobile
phone, GPS navigation system,
etc.) is free of dust and grease.
Use a suitable cleaning agent from
a specialised dealer to clean the
surface.
• Please note that certain car care
products (such as cockpit sprays
and similar) may reduce the
adhesive strength of the pad. Thus
the surface should be thoroughly
cleaned before the pad is attached.
• Various environmental factors, such
as ambient humidity, sunlight and
cold, can impair the durability of
the adhesive pad.
• We cannot guarantee that no
residue will be left on the mounting
surface after the adhesive pad is
removed.
• Please note that the adhesive patch
requires 24 hours to reach its full
load-bearing strength.
• Please note that a thick protective
cover may reduce the effectiveness
of the magnetic clasp.
• Please note that dust and dirt that
gets between the mobile phone
and the magnetic pad may cause
scratches.
• Please note that the magnetic
pad inside is manufactured out of
metal and therefore may impair
the transmitting and receiving
performance of your phone.
• Remove the protective foil (1) from the
adhesive side of the magnetic pad and
press the pad against the surface in the
desired position (2) for a few seconds.
• Remove the protective foil (3.a) from
the metal plate (round or rectangular)
and press it against the desired
adhesive surface (such as the rear of
the mobile phone) for a few seconds.
• The metal plate (3.b) can simply
be inserted or stuck between the
protective cover and the back of the
mobile phone.
5. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability
and provides no warranty for damage
resulting from improper installation/
mounting, improper use of the product
or from failure to observe the operating
instructions and/or safety notes.
6. Service and Support
Please contact Hama Product Consulting
if you have any questions about this
product.
Hotline: +49 9091 502-115 (German/
English)
Further support information can be
found here:
www.hama.com
3