GLOBBER PRIMO Bedienungsanleitung Seite 8

Keep the instructions for future.
Helmet 505/506/507/FCJ-301/FCJ-301i
This helmet is not suitable for roller acrobatics on ramps or in
streets.
Complete protective equipment includes knee, elbow and wrist
guard pads and helmet.
This helmet is design to protect impact cause by falling or ejected
objects and collision of head with an obstacle while cycling or
roller skating, it has passed EN 1078:2012+A1:2012 to show
conformity to the EHSR of EU 2016/425, please read the following
instructions carefully to ensure your safety.
Conform to European regulation (EU) 2016/425
Part I. How to fit a helmet.
A. Choosing the correct size helmet is very important. For
optimum protection this helmet must fit comfortably on the head.
Adjust the straps so that they form a «Y» below each ear then
snap the buckle together and position the straps. The straps must
be tighten against the throat and the loop closing being correctly
locked, the buckle should be positioned away from the jawbone.
B. With the helmet on and tightly fastened, make sure it cannot
be removed from your head or rolled forwards or backwards
excessively.
C. When properly fitted and adjusted, your ears should not be
covered by any part of the straps and your peripheral vision
should not be blocked.
Adjustable Knob:
Place the helmet on your head. Turn the adjustable knob
clockwise until the headband is firm yet comfortable. If you need
to loosen the headband, TAKE THE HELMET OFF, turn the
ring counterclockwise. All fit adjustments must be made with the
helmet in the proper position. Failure to do this will result in a poor
fit. A poor fit will allow the helmet to move out of position or come
8
off in an accident. For proper turn ring operation, refer to the
image below.
How to operate the lights.
- There are 3 lighting modes (on / flash / fast flash), simply press
the button on the knob and you will see the different lighting
effects available. Press the button 4 times to switch off the
lights.
- Battery life is 24 hours in continuous ON mode and 65 hours in
flashing mode.
- Required 1 x CR2032 (3V), included in-pack.
1 2 3