Installation; Operation - Emos H8108 Gebrauchsanleitung

GB | WI-FI Door/Window Alarm
Safety Instructions and Warnings
Read the user manual before using the device.
Follow the safety instructions stated in the manual.
The product is designed to provide trouble-free service for many years if used properly.
• Read the manual carefully before using this product.
• Do not place the product in locations prone to vibration and shocks – these may cause damage.
• Do not expose the product to excessive force, impacts, dust, high temperatures or humidity
- these may cause malfunction, shorter battery life, damage to batteries and deformation
of plastic parts.
• Do not place any open flame sources on the product, e.g. a lit candle, etc.
• Do not disassemble, repair or modify the product. Have it repaired by the retailer you
bought it from.
• Do not tamper with the internal electric circuits of the product – doing so may damage the
product and will automatically void the warranty.
• Do not replace any components of the product with non-original spare parts.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning
agents - they could scratch the plastic parts and cause corrosion of the electric circuits.
• Do not immerse the product in water or other liquids. The product may not be exposed to
dripping or splashing water.
• Keep this product out of the reach of children. The product may be used by persons with
impaired physical, sensory or mental capabilities or persons without experience and knowl-
edge only if they are supervised or instructed in the safe use of the product and understand
the risks that may occur.
Description
See fig. 1
1 – magnet
2 – sensor with wi-fi
3 – contact surface

INSTALLATION

Installing Batteries
See fig. 2
– 2× AAA
Installing the Device
Before installing the device, pair it with your router (see section Application).
Install the device using the enclosed tape.
Stick the sensor with Wi-Fi onto the window/door frame and stick the magnet onto the moving
portion of the window/door.
See fig. 3
Proper functioning requires:
• sufficient Wi-Fi signal in 2.4 GHz band with access to the Internet
• router with DHCP function enabled
• distance between sensor and magnet of max. 5 mm
• both parts must be almost level with each other when the window/door is closed
See fig. 4

OPERATION

Button
1× press – alarm mode selection
2× press – deactivates the siren when the alarm is triggered
Long press – reset to factory values
4 – button
5 – status LED
6 – siren
7