Herunterladen Diese Seite drucken

FormaLighting Zero Projector Series Installationsanleitung

Werbung

Installation Instruction
Istruzioni di montaggio
Installationsanleitung
Instructions d installation
Instrucciones de montaje
ZERO
PROJECTOR
"Shapping" Track Lighting
Apparecchio da binario con sagomatore
Framing-Projektor auf Schienen
Projecteur de cadrage sur rail
Luminarias para carril con haz regulable
CAUTIONS
AVVERTENZE, WARNUNG
PRECAUTIONS, PRECAUCIONES
1. Switch-off the power supply before any installation
and maintenance operations.
Use only a two-pole switch
Staccare la linea elettrica prima dell installazione
e di ogni intervento di manutenzione.
Utilizzare un interruttore bipolare
Die Stromzufuhr muss vor der Installation /
Wartung ausgechaltet werden.
Nur mit einen zweipoligen Stecker
zu verwenden
Couper la source d alimentation avant toute
installation et opération d entretien.
Seulement utiliser avec un
connecteur bipolaires
No efectuar la conexión de la
lámpara con la tensión general
activada.
Usar un interruptor bipolar
2. Installation must be carried out only by qualified
personnel according to safety norms and local
regulations.
L installazione deve essere effettuata da
personale qualificato secondo la normativa
elettrica vigente.
Die Installation muss nach den gültigen
Art.
Sicherheitsvorschriften durch einen
konzessionierten Elektroinstallateur erfolgen.
6484
6485
L installation doit etre realisée par un électricien
6542
qualifié en respectant les prescriptions en
vigueur.
La instalación debe ser realizada por una
persona cualificada y de acuerdo a la normativa
vigente.
3. Use this light fixture at the rated voltage and
frequency as indicated on the specification table.
Utilizzare questo apparecchio a tensione e
frequenza indicate nella tabella.
Die Leuchte darf nur mit der angegebenen
Spannung und Frequenz betrieben werden.
Respecter les prescriptions de tension et de
fréquence indiquées dans le tableau final.
Utilice esta lámpara a la tensión y frecuencia
indicadas en las instrucciones.
4. This installation manual must be retained by the
person responsible for the installation and
maintenance of the product.
Queste istruzioni di montaggio devono essere
conservate dal responsabile dell installazione e
manutenzione dell apparecchio.
Bewahren Sie diese Gebrauchsanweisung für
den verantwortlichen Benutzer /
Wartungstechniker auf.
Gardez cette instruction pour I utilisateur /
technicien de maintenance.
Estas instrucciones deben ser conservadas por
el responsable de mantenimiento de la
instalación.
V.001

Werbung

loading

Inhaltszusammenfassung für FormaLighting Zero Projector Series

  • Seite 1 Installation Instruction 2. Installation must be carried out only by qualified personnel according to safety norms and local Istruzioni di montaggio regulations. Installationsanleitung L installazione deve essere effettuata da Instructions d installation personale qualificato secondo la normativa elettrica vigente. Instrucciones de montaje Die Installation muss nach den gültigen Art.
  • Seite 2 INSTALLATION INSTALLAZIONE, MONTAGE INSTALLATION, INSTALACIÓN LIGHT FOCUS ADJUSTMENT REGOLAZIONE DELLA DISTANZA FOCALE LICHT FOKUSEINSTLELLUNG AJUSTEMENT DE LA DISTANCE FOCALE ó REGULACI N DE LA DISTANCIA FOCAL Focus V.001...
  • Seite 3 LIGHT SHAPE ADJUSTMENT REGOLAZIONE CON SAGOMATORE LICHT FORMANPASSUNG AJUSTEMENT DE LA FORME DU FAISCEAU FOCALE REGULACION CON PROYECTOR DE CONTORNOS Art.6542 Light shape Art.6484 25°- Dist.(m) Diaphragm 25° 4132 1033 25° - Dist.(m) Art.6485 25° 4176 1044 LOGO V.001...
  • Seite 4 Para reemplazar el LED, por favor contacte con nosotros. in mm IP20 Art. 6484 Forma Lighting (Italia) S.r.l. : (+39) 02 9354 0300 : formaitalia@formalighting.it Email 224 (25° beam angle) : (+39) 02 9343 5117 : Via Europa, 35/A Address 260 (15°...

Diese Anleitung auch für:

Gobo projector 66Framing projector 100Iris projector 66