Safety System; Thermostat Control; Cleaning And Maintenance; Installation - Johnson Roko Betriebsanleitung

GB
Parts
A. Selector:
off,
ventilation,
heating at 1000 W,
heating at 2000 W
B. Thermostat control knob
C. Power indicating light
D. Integrated handle
E. Device for automatic shut-off
if the heater tips over
F. Rotating diffuser grid by engine
G. Rotary switch diffuser grid

SAFETY SYSTEM

The appliance comes with two safety sy-
stems that intervene by automatically tur-
ning off the appliance if it overheats or
tips over.
If the machine is turned off due to over-
heating, disconnect the plug from the
power outlet for a few minutes and turn
selector (A) on (0).
After eliminating the cause of the over-
heating, reconnect the appliance to the
mains power and reset the operating con-
ditions.
If the machine is turned off due to tipping
over, disconnect the plug from the power
outlet and turn selector (A) on (0).
Reposition the appliance correctly, recon-
nect the appliance to the mains power and
reset the operating conditions.

INSTALLATION

Place the appliance on a flat stable surface
away from inflammable materials (cur-
tains, table linen, etc).
Place selector (A) on (0) and insert the plug
into a compatible power outlet.

OPERATION

- Only ventilation: turn selector (A) and set
it on the relative symbol
- Heating: set the thermostat control (B)
on the maximum value.
- Operation at low power:
- Operation at maximum power:
- To increase air diffusion, start up the ro-
tation of diffuser grid F by pushing the
switch G.
- Shut-off: turn selector (A) on (0).
When the room to heat has reached the
desired temperature, turn the control
knob (B) of the thermostat in a counter
clockwise direction until a click is heard.
The appliance turns off.
The action of the thermostat will automa-
tically keep the temperature constant.
Before carrying out any cleaning opera-
tion, always disconnect the plug from the
power outlet.
Keep the air inlet and outlet grills free and
clean.
Only use a non-abrasive cloth to clean the
surfaces, do not use cleaning powders or
solvents.
.
20
set selector (A) on 1 (1000 W).
set selector (A) on 2 (2000 W).

THERMOSTAT CONTROL

CLEANING AND MAINTENANCE