To Fill The Gun From Bulk Container; To Fill The Gun With A Filler Pump - Lincoln Series C Bedienungsanleitung

3. Reassemble follower into grease tube
assembly and position with the follower
handle so that the grease tube assembly
cap can be tightened onto the container
tube.
Rear Side
Figure 2

To Fill The Gun from Bulk Container

1. Remove pump assembly from grease tube
assembly.
2. Pack lubricant into cavity of the pump as-
sembly.
3. Insert the open end of the grease tube
assembly into lubricant (see Fig. 3). Slowly
pull the follower handle back while pushing
the grease tube assembly deeper into the
lubricant to prevent air pockets from being
pulled into the grease tube assembly.
4. When the follower rod is fully extended,
pull it sideways to latch the rod groove into
the keyhole slot in the grease tube assem-
bly cap.
5. Loosely assemble the pump assembly to
the grease tube assembly. Release the fol-
lower rod from the grease tube assembly
cap and disengage the follower rod from
the follower by rotating the follower handle.
Push the follower rod into the grease tube
assembly. Slowly unscrew the grease tube
assembly from the pump assembly until
lubricant oozes from the interface. Tighten
grease tube assembly into the pump as-
sembly.
Figure 3
Form 404088
Models 1400, 1442, 1442E, 1444, 1444E
To Fill The Gun with a Filler
Pump
1. Engage the follower rod with the follower
2. Insert the gun vent/bulk fill valve into the
3. Operate the filler pump to fill the container.
4. Disengage the follower rod from the
Front Side
Remove Air Pocket! Air pocket at grease
inlet will prevent grease from being pumped.
Unscrew the vent/bulk fill valve two full turns to
remove small air pockets trapped in this area.
If the air pocket is substantial and no grease
flows from coupler after trigger is pulled for 15
seconds, see following steps.
To Expel Air Pockets
1.
2.
3.
4.
5.
6.
7.
PowerLuber Grease Gun
by rotating the follower handle.
filler pump socket (see Fig. 4).
When the follower rod groove is exposed,
the grease tube assembly is filled. The fol-
lower rod will be extended approximately 8
inches (20 cm). Do not overfill!
follower by rotating the follower handle.
Push the follower rod into the grease tube
assembly.
Withdraw the follower rod from the grease tube
assembly cap and engage it with the follower by
rotating the follower handle.
Unscrew the vent/bulk fill valve two turns. Exert
force on the follower handle until grease flows
through the opening in the vent/bulk fill valve.
Tighten the vent/bulk fill valve.
Pull the trigger in short bursts to operate gun
until trapped air is expelled. Disengage the
follower rod from the follower by rotating the
follower handle. Push the follower rod into the
grease tube assembly.
If step 2 fails, unscrew the grease tube assem-
bly 3 turns from the pump assembly.
Exert force on the follower handle until lubricant
oozes from the grease tube assembly and
pump assembly interface.
Tighten grease tube assembly into the pump
assembly. Disengage the follower rod from the
follower by rotating the follower handle. Push
the follower rod into the grease tube assembly.
Figure 4
Page Number - 7