Specifications; How To Use; General Settings - TESLACIGS WYE II Anweisung

Thank you for choosing Teslacigs!
Please read this manual carefully prior to using.We are not responsible for any intentional damage
or improper use. If you require any additional information or have any questions about the product
or its use, please contact us via www.teslacigs.com.

SPECIFICATIONS

Dimension: 86*56*30mm
Material: PC+ABS
Cell
Type: two hi-rate 18650 cell(discharge current should be above 40A)
Weight: 72g
Output
Mode: KA/TC-SS316/TC-Ni200/TC-Ti/TCR mode
Output
Wattage: 7-215W(in 0.5W increments)
Max Output Voltage: 7.5V
Max Output Current: 50A
USB:5V/1.5A
Taste Mode:Norm/Soft/Hard/User
Memory Mode: M1/M2/M3
Resistance
Range: 0.1-3.0ohm
KA
mode/0.05-1.0ohm
for
Ti/Ni 200/SS316/TCR
mode
Temperature Range: 100-300℃/200-600℉

HOW TO USE?

1. Power On: Remove the battery cover and insert two high-rate 18650 cells into the device body.
The device will power on and display the TESLACIGS Logo.
2. Power Off: Press the fire button 5 times continuously to turn off the device.
3. Vaping: Press and hold the fire button to vape. Release the fire button to stop.
4. Power Lock/Unlock: In KA mode, hold down both up button and down button to lock/unlock
the device power.
5.Temperature Lock/Unlock: In TC/TCR mode, hold down both up button and down button to
lock/unlock the temperature.
6. Adjust Power Option: When the device is powered on, press the up/down button to adjust
wattage accordingly. Wattage will move in .5 increments. Press and hold up or down button to
adjust wattage rapidly.
7. Smart Mode: In power mode, the device can automatically select adaptive output power for
according to the resistance reading of the atomizer.
8.New Coil, Same Coil: When you connect a new atomizer or disconnect and reconnect your
existing atomizer, the device will prompt you to confirm this change. if you have attached a new
atomizer, press the UP button. If you have disconnected and reconnected the same
atomizer, press the DOWN button.
Note: Each histogram represents 1 second. Press the up/down button to adjust the current wattage, then press fire to move to the next
histogram. Once finished, the screen will prompt Test, Reset or OK. You can test the setting first to make sure everything is ok, then selecting
the OK option will return you to the home screen.
Output Mode: When entering the output mode sub-menu, you can cycle through the supported
materials or enter your own TCR value on the TCR setting.
Temp Mode:Temperature control
mode
screen
display
information(resistance,output
wattage,
temperature,
taste
control,
output
mode,
battery
level,
memory
mode)
TCR Mode: With the new TCR (Temperature Coefficient of Resistance) function available
on your device, you can now customise your temperature control coils (Ni200/SS316/Ti) on
your own. Here's the TCR value range as a reference:
PROTECTIONS
1. Over Puffing Protection: Device will deactivate after prolonged continuous puffs of more than
10 seconds. The s creen will flash !!Long Vaping!!
2. Low-Voltage Protection: When the voltage/power is too low, the screen will display "Low
Battery." Please recharge the device.
3. No Atomizer Protection: If no atomizer is attached to the device, the screen will display "No
Atomizer."
4. Atomizer Short Protection: The d evice has internal controls to protect against atomizer shorts.
With KA coil, resistance below 0.1ohm.
With Ti/Ni 200/SS316 coil, resistance below 0.05ohm.
5. Reverse Connection Protection: If batteries are inserted incorrectly, the device will not power
on and will prevent any damage to the chipset.
6. Automatic Power Adjust Protection: Using this device under high wattage situations when the
battery is at low voltage/power conditions, the
adjust the output wattage power to be used in safe normal modes.
7.Temperature Alert: if the internal board temperature becomes excessive, the output will shut
off automatically and the screen will display "Too Hot".
8.Temperature Protection: In TC modes, if the actual temperature of coil exceeds the set
temperature, the device will shows "Temp protect".
01 English
03 English
05 English
battery sign will flash continuously and will auto
07 English
English/French/German/Spanish/Dutch/Russian/Italian/中⽂简体
02 English

GENERAL SETTINGS

Menu Switching: Press the fire button 3 times consecutively to enter the menu switching state
whilst the device is on, then press the down button to switch between resistance settings,
resistance lock/unlock, taste mode, output mode, version information and memory mode. Press
the fire button to enter the sub-menu.
Resistance Setting: When entering the resistance value sub-menu, you can fine-tune the resistance
within a range of plus / minus 0.05.
Resistance Lock/Unlock: When entering the "Ω" sub-menu, switch between
"

"/"Ω"
to
lock
/unlock the coil resistance.(Note: Such operation should be carried out at room temperature.)
Taste Mode: When entering "NORM" sub-menu, the screen will display NORM/SOFT/HARD
/USER.
User Mode: This feature allows you to fine-tune the power curve to your own custom setting
before 10 seconds of output wattage. This can only be used in KA mode.
04 English
Material
SS316
Gold
Ti
Co
Nife
Ni200
Version Information: When entering the battery icon sub-menu, the screen will show the
hardware version, software version and product model.
Memory Mode: When entering the M sub-menu, you can save the current setting parameters to
memory mode. This includes Wattage/TCR/Temperature/Output mode/Taste mode. You can set
three groups of data.
06 English
REMARKS
This package does not include 18650 cell or charger.
Please choose suitable 18650 cell, the cell should be discharged 40A or above.
Please do not keep the e-liquid inside the atomizer if the device will not be used for a long period
of time.
Please take out the battery from the device when it's not used for a long time.
Please turn off the device when it's not used for a long time.
CAUTIONS
1.Not intended for use by children under 18 years old, pregnant or breastfeeding women, or
anyone at risk of heart disease, depression, or asthma.
2.Keep out of reach of children and pets.
3. Do not attempt to repair the product by yourself as damage or personal injury may occur.
4. Do not leave the product in high temperature or damp conditions, otherwise it may be damaged.
5. Do not use this product for other purposes except only for vaping and don't swallow the e-liquid.
6. This product may be hazardous to health and contains nicotine which is addictive.
7. For people with adverse reactions after use of this product, it is recommended to stop using this
device immediately and consult your doctor.
08 English
TCR Value Min TCR Value Max
0.00060 0.00150
0.00300 0.00400
0.00400 0.00370
0.00381 0.00390
0.00391 0.00550
0.00570 0.00700