AQUAJAM AJ2 Bedienungsanleitung Seite 11

THE 3M MOUNT IS AN INDUSTRIAL STRENGTH WATERPROOOF
MOUNT. It can be used on a variety of surfaces and in outdoor
1. To install a mount remove the mounting hole cover,
unscrew it from the speaker.
2. Once the cover is removed take the Mount and twist it 90 degrees in
a anticlockwise motion into the accessories mounting hole. Make sure
the mount is securely attached to the speaker.
3. Apply the mount to a smooth, and fully cleaned surface.
A textured surface or any imperfections to a smooth surface can
keep the adhesive from making a strong bond.
4. Firmly press the mount into place ensuring full
contact over the entire surface area.
5. Be sure to apply the mount at room temp, and also allow at least
24 hours for the mount to properly adhere to the surface.
To remove the adhesive mounts, you can use a hairdryer or
heat gun to soften the adhesive and slowly peel it back.
Please note that you will not be able to reuse an adhesive
Installing the 3M
Multipurpose Mount
environments.
mount once you remove it.
10.
ENG