Rear View - Sony PWS-100TD1 Handbuch

c TEMP indicator
If an abnormally high temperature is detected within the
unit, the indicator turns on red.

Rear View

a SYSTEM TC connector
Not used by this system.
b Remote connectors (1/2, 3/4, 5)
Connect VTR devices to the Remote 1/2 and Remote 3/4
connectors, using the RJ-45 D-sub conversion cable
(supplied) and commercially-available 9-pin remote
cables, for VTR remote control operation. You can
connect two VTRs using a single RJ-45 D-sub conversion
cable and two 9-pin remote cables.
The Remote 5 connector is not used by this system.
c AC power supply units
Insert the power cords and connect to power outlets.
Only one AC power supply unit is installed at the factory.
A second optional power supply unit can be installed to
provide power supply redundancy. When used in systems
that require reliability, power supply redundancy allows
the unit to continue operating even if a power supply unit
fails.
For details about installing or replacing a power supply
unit, consult your Sony sales or service representative.
d SDI (1 to 4) connectors
SDI1 to SDI4 connectors are numbered from left to right.
Connect to a VTR device or external monitor, using an
SDI cable, to input/output SDI signals.
Connect a sync reference signal SDI input to the SDI 1
connector.
e REF IN connector
Not used by this system.
1 1
LAN1 LAN2
4 5 6 7
d HDD status indicators
If a warning is generated for an HDD, the corresponding
indicator turns on red. The indicator turns off if the
corresponding HDD fails, is in sleep state, or has been
removed.
2 3
1 1 2 3 4 5
6 8 9
f USB connectors (rear panel)
Connect to drive units using USB cables.
USB devices not described in this document are not
supported.
Notes
• Of the four USB connectors on the rear panel, only the bottom right port
supports power delivery (900 mA). The other three ports do not support
power delivery, and should be used to connect USB devices that do not
require power supplied from the USB connector.
• Use SuperSpeed USB cables.
g LAN connectors
Connect to a Gigabit Ethernet network.
h HDMI connector
Connect to a monitor using an HDMI cable.
Use only Sony-brand HDMI cables.
Recommended cable (example): DLC-HE20XF
HIGH SPEED HDMI cable (2 m ((6 ft.))
i DisplayPort connector
Connect to a monitor using a DisplayPort cable.
Use the following recommended cable.
• LINDY 41630 4K-compatible DisplayPort cable (1 m
(3 ft.))
The compatibility of the following displays has been
confirmed.
• Sony: BVM-F170
• ASUS: PB248Q
Note
Use an active-type cable if using a DisplayPort-DVI conversion cable or
DisplayPort-HDMI conversion cable.
19
Name and Function of Parts