Operating Methods - Mc Haus ARTIC-20 Betriebsanleitung

OPERATING METHODS

1. COOL Mode
• When the appliance enters the cooling mode automatically or the cooling mode is selected after it
has been switched on, the cooling indicator light turns ON.
• Press the Up/Down key to adjust the set temperature (16ºC- 30ºC).
• Press the Speed key to choose High/Medium/Low speed.
2. FAN Mode
• When the mode key is pressed or Fan mode is selected by pressing the remote control, the wind
indicator light will come on.
• Press the Speed key to choose High/Medium/Low speed.
• The temperature cannot be adjusted.
3. DEHUMIDIFY Mode
• Pressing the mode key or choosing the dehumidification
mode by pressing the remote control, the dehumidification
indicator light illuminates.
• Remove the dehumidification water wedge, insert the water
trap, place the other end of the water trap into the water
container or drain pipe, as shown in the figure at right.
• After entering the dehumidification mode, if the ambient
temperature is below 17°C, the compressor is ON. Then
check as follows: when the ambient temperature is below
15°C
• The temperature cannot be adjusted.
4.TIMER mode
• In standby mode, press the Timer key to set the ON time. Press
the Up and Down keys to set the power-on time (1-24H), and
the timer indicator light will illuminate.
• In the ON state, press the timer key to set the off time. Press the Up and Down keys to set the power off time
(1-24H), and the timer indicator light will turn on.
DRAIN OPERATION
This product is equipped with an automatic water vaporization
system. The condenser is cooled by the circulation of the condensing
water to improve cooling efficiency and save energy.
If the inner vessel is filled with water, the display will show "FL" and
the compressor will automatically stop working. After turning off the
power, unscrew the water cover, pull out the water wedge to drain
the water and the water will become normal after restarting.
ARTIC-20