First Steps - Mima moon Gebrauchsanleitung Und Gewährleistung

2

FIRST STEPS

1. Assembling the base
Put the base of the chair on the floor, insert the
pneumatic cylinder, aligning the widest end of the
cylinder with the corresponding groove at the base. Push
the cylinder down to make sure that it fits into place
properly.
2. Assembling the cylinder cover
1
Put the cylinder cover on and turn it around twice until it
fits.
3. Assembling the seat
Insert the end of the seat frame in the cylinder and
push downwards with your body weight to make sure it
is secured on the cylinder. Lift the seat and if the base
remains attached them the seat has been secured.
Make sure that the cylinder goes into the end of the seat
frame correctly.
4. Removing the high chair seat
Press the button at the bottom front of the
seat to release it.
3
Lift it up and out, so that just the junior chair seat
remains.
5. Assembling the safety bar
Install the safety bar on the high chair seat. First, fasten it
on the side and then the screws underneath.
4
5
EN
7