Kemper KTS Einbau- Und Bedienungsanleitung Seite 17

Configuring the log file:
The configuration of the log file is explained
below using the
ThermoBox as 2x cascade:
Open the log file with the name DAT in
MS-EXCEL.
In Cell A1, state the intervals in which
the values will be saved. In this
example, a storage rate of one second
is stipulated. If you want to save every
10 seconds, for instance, replace the 1
with a 10.
As delivered:
Time interval changed to 10 seconds:
In the column under ModBus ID, select
the corresponding ThermoBox from
which to read out the data.
Modbus ID 1 activates the master unit,
and
with ModBus ID 2, the slave unit is
activated.
With this configuration, all temperature
values and volume flows of both cascade
units are saved. Additional values can also
be saved, or, if they are not necessary, they
can be deleted.
The data points, register addresses and the
related settings can be taken from the KTS
ModBus data-point list.
K410095502001-00 / 06.2018
example of a KTS
7