Gorenje TC 80 Z Gebrauchsanweisung Seite 31

mode is checked every 2 hours by switching on the fan for one minute. If the
temperature of inlet air is higher than 7 °C the heat pump switches to normal mode of
operation (symbols 16 and 20 are displayed). The heaters switch off. The heat pump
is on, the screen remains unlit and inactive.
Setting the clock and day of the week

Hold field no. 12, until field no. 7 shows a flashing number of the day of the week.

By pressing + or – you can set the number of the day of the week
(1 – Monday, ..., 7 – Sunday).

Press field no. 12 again (flashing hour setting is displayed).

By pressing + or – set the hour (by holding + or – you can speed up the setting).

Press field no. 12 again.

Flashing minute setting is displayed.

By pressing + or – set the minutes (by holding + or – you can speed up the setting).

The setting is stored when you press field no. 12, or when the field stops flashing.
Setting the temperature

Press field no. 5 (the set temperature starts blinking).

By pressing + or – you can change the temperature setting from 10 °C to 75 °C
(preset to economic temperature of 55 °C).

The setting is stored by pressing field no. 5 again, or when field no. 5 stops
flashing. After a few seconds, the display shows the actual temperature.

In case of power failure, the last stored value is restored.
Switching on the "TURBO" mode

If you need more warm water than the heat pump can heat up in a short period of
time, press field no. 13 (switches on the "TURBO" mode). The heat pump and
heater work simultaneously. The screen shows symbols no. 14, 16 in 20. When the
temperature reaches 55 °C the heating pump returns to the mode used before the
"TURBO" mode.
Switching on the "HOT" mode

If you want to heat the water to the maximum temperature of 75 °C, press field no.
15. The heat pump will heat water to 55 °C. The screen displays symbols no. 16 in
20. When the temperature in the boiler reaches 55 °C the electric heater turns on to
heat the temperature up to 75 °C. The screen displays the symbol no. 14. When the
temperature reaches 75 °C the heating pump returns to the mode used before the
"HOT" mode.
Display of the quantity of water in the heat pump
The display shows the symbol: - no warm water
- low quantity of warm water
- high quantity of warm water
31