Water Supply - Ugur UBM 60 Bedienungsanleitung

C- INSTALLATION OF ICE MACHINE

Water Supply

Make sure that the water to be used in your device is absolutely fresh potable water.
You can use water filtered through a water filter in your device
If the water used is hard, lime, corrosion may occur on the machine parts
If chloride rate of the water used is high, always use carbon filter. Chloride will ruin taste of ice.
Installation
Before positioning, remove and disassemble all packaging materials of the product.
Note than ice basket and ice scoop are inside the box. If any part or accessory is missing, please contact
to our customer care service.
Before using the device, clean inner chamber with warm water and a soft cloth.
Clean evaporator rods with warm soapy water. Dry them with a soft cotton cloth.
After removing the device from the box, wait for an (1) hour for the settlement of the coolant gas.
Insert the replacement parts inside your product according to the installation instructions.
Only use genuine Uğur spare parts. Inauthentic spare parts may constitute danger for you and damage
your device.
Consider the placement rules written in the manual while positioning the product.
EN
31