Selecting The Place Of Installation - Ugur UBM 60 Bedienungsanleitung

C- INSTALLATION OF ICE MACHINE

Selecting the place of installation

The operating environment of the product is very important. While selecting the operating environment,
• Do not place your product exposed to outdoor environment (on the street, avenue etc.)
• Do not place the product near heat resources (stove, radiator, electric heater etc.). (Picture 1)
• Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Pictu-
re 2)
• Do not expose to direct sunlight. Heating may occur on your product when it is exposed to direct sunlight.
• Your device gives optimum cooling performance under the ambient with temperature of 30°C and humidity of
55%. Therefore make sure that operating environment of the device at or below these temperature levels
• Be careful for not placing cardboard, box etc. in front of the side and back ventilation grill of the device for a
proper operation. If you place another device next to it, always leave a gap of 100 mm (10 cm).
• Air inlet and outlet must absolutely be fluent and free for proper operation of the compressor section of your
device.
• While approaching your device to the side of wall, be careful that there is a gap of 200 mm (20 cm) between the
wall and back of your cooler.
EN
PICTURE 1
1. Power Supply
2. Fuse
3. Socket
4. Water Filter
5. Tap
6. Water Supply
7. Flush (with 3 elevation in each meter)
8. Flexible connection between the device and water
supply (1.5)mt
30
PICTURE 2