Clever Home LINN Bedienungsanleitung Seite 5

English
Handset modes
The new Linn handset has two operating modes, Disc mode and Amp
mode.
DVD CD
AMP
CD
Press for Disc mode
DVD
Press for Amp mode
AMP
SHIFT
UNIDISK 1.1 and 2.1
For operating a UNIDISK 1.1 or 2.1 the handset should be in Disc mode.
● To put the handset in Disc mode, press DVD.
UNIDISK SC
For operating a UNIDISK SC the handset should be in Disc mode when you
want to use the disc keys (play, pause, skip forward, etc.) and should be in
Amp mode when you want to use the following pre-amplifier functions:
trim adjustment, balance adjustment, auxiliary source selection.
● To put the handset in Disc mode, press DVD.
● To put the handset in Amp mode, press AMP.
KISTO, KINOS and EXOTIK
For operating a KISTO, KINOS or EXOTIK the handset should be in Amp
mode. This allows access to the functions marked in blue (Audio Adjust,
Lip Sync, etc.).
● To put the handset in Amp mode, press AMP.
OFF
DISC TRACK A-B
1 2 3
SHUFFLE INCLUDE EXCLUDE
4 5 6
LISTEN RECORD SIGNAL
7 8 9
0
STORE SURR
You may find that on occasion when using the handset that the unit does
not respond as expected. The likely reason is that the handset is in the
wrong operating mode. To correct this, simply press either the DVD key
for Disc mode, or the AMP key for Amp mode.
Changes from the Owner's Manual
The changes between the functionality of the new Linn handset and the
instructions in the Owner's Manual are as follows:
UNIDISK 1.1 and 2.1
The AUDIO key on the new handset replaces the AUDIO ADJUST key.
The SHIFT key on the new handset replaces the PROG key.
The DISC key on the new handset replaces the REPEAT key for the
Repeat disc function.
The A-B key on the new handset replaces the REPEAT key for the Repeat
section function.
The most significant change to the operation of the UNIDISK 1.1 and 2.1 is
that the DISP key on the new handset replaces the VIDEO ADJ key. This
means that the Video Output section of the manual on page 7, should read
as follows:
Video Output
In order to set up your UNIDISK 1.1/2.1 you must first ensure that the unit
is outputting the correct video signal type for your display device.
To do this:
● Press and hold DISP (display) on the handset. The current setting
for the output video format is shown on the front panel display.
To change the video format, press
available are PAL, NTSC, and Native (for display devices that accept
both PAL and NTSC).
(left) or (right) . The options