Skytec TEC 070 Gebrauchsanleitung Seite 7

choose the end point (mend by Point B). Then the DVD player repeats the part between
A and B. Press the A-B key for the third time, you can cancel the preset part repeat and
return back to normal play.
• REPEAT key: With the repeat key, you can repeat to play any title, paragraph, song or all
the disc.
• MENU key: When the DVD player is playing DVD disc, press the MENU key to change
subordinate menu, and press the MENU key again to return to the main menu.
PLAY DVD OR USB/SD CARD:
DVD
1. Slide the POWER switch to "ON" position
2. Slide the SOURCE select switch to DVD position. Open de tray to load a disk.
3. Press PLAY button begin to play.
4. Press REPEAT button once time, REPEAT indicator 'flash' means repeat a single track.
Press two time, REPEAT indicator light 'ON" means repeat all tracks.
USB/SD
1. Slide the POWER switch to "ON" position
2. Slide the SOURCE select switch to DVD position. Check if there is no disk in the unit. If
there is a CD remove the CD and close the tray.
3. Press PLAY button begin to play.
4. Press REPEAT button once time, REPEAT indicator 'flash' means repeat a single track.
Press two time, REPEAT indicator light 'ON" means repeat all tracks.
MICROPHONE:
Wired:
1. Inset the microphone to the MIC1 or MIC2 jack.
2. Adjust the MIC volume and tone control for each channel.
3. Adjust the master microphone volume and echo control.
Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the warnings contained in this
manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a disrespect of the safety recommendations and warnings. This is also
applicable to all damages in whatever form.