Destiny; Principle Of Auto-Darkening Filter; Safety And Handling - Welder Fantasy 3031S Anweisung

II. D
ESTINY
Darkening welding helmets are designed to protect the eyes and face from sparks, spatter and harmful radiation
resulting in normal welding.
Welder welding helmets Fantasy (LY500) suitable for use as personal protection during welding and cutting arc (TIG,
MIG, MAG, MMA, PAC, PAC).
It is forbidden to use the same dimming helmets as a means of personal protection during welding and gas cutting,
welding and laser cutting.
Visor can also be used as a means of personal protection during minor and short grinding (grinding metal surfaces using
a serrated discs, not suitable for personal protection during metal cutting discs grinding).
III. P
RINCIPLE OF AUTO
Darkening welding filter that comes with the helmet works automatically by switching the state of darkened or
lightened to reverse.
Entering the darkened occurs at the time that the welding arc. Entering the lightened occurs after the expiration of the
welding arc.
IV. S H
AFETY AND ANDLING
Before using the darkening helmet should be sure to read this manual. Observe safety rules prevailing in the workplace.
In case of any irregularities in the functioning of the helmet, doubts about its proper use, you should report it to your
supervisor or contact your local dealer.
1. It is forbidden to use non-approved helmet.
2. Before starting any work necessary to assess technical efficiency darkening helmet. The correct operation of the
filter can be checked with the "TEST".
3. Depending on the welding process which joins the user to select the appropriate degree of darkening filter.
4. In case of any irregularities in the functioning of the helmet. In particular, the auto-darkening filter incorrect (for
example: no blackouts filter blackout too late, too early to lighten), damage to the body of the helmet, etc.
discontinue use and report the problem to your supervisor.
5. The helmet does not protect against explosive devices or corrosive liquids.
6. Do not put the helmet and auto-darkening filter on a hot surface.
7. Protect filter from liquids or dirt. Avoid contact with water or excessive moisture.
8. Renew a protective windscreen. Using the original glass.
9. Regularly clean the surfaces of the filter, do not use strong cleaning solutions.
10. Sensors and solar cells behave always clean.
11. Do not make any modifications in the construction of the filter or the helmet. Do not use parts other than those
supplied by an authorized service center. Unauthorized modifications and replacement parts will void your
warranty and expose the operator to the risk of injury.
12. It is forbidden to open and manipulate the filter dimming.
13. Use at: - 5C : +50C
14. Store at: -10C : +65C
13/36 Welder Fantasy® 3031S
(LY500) | AUTO-DARKENING WELDING HELMET
-
DARKENING FILTER