Quick Reference - Reflexion MOBILSAT-1 Bedienungsanleitung

3-3. Quick Reference

Classification
Setting
&
Connecting
Operating
(Searching the satellite)
WARNING
When you move MOBILSAT-1, the flat dish of the antenna must be be in the
Home position.
NOTE
•
•
•
10
1. Take out the antenna from carrying case, and place it on the flat ground(or
mount it on the top of the camper) facing South & no obstacle.
2. Connect the left port of the antenna, which located at the rear of the main
unit, to the controller using controller cable.
a. One end of the controller cable connect to "controller" port of the main unit
of the antenna.
b. The other end of the controller cable connect to the port of the controller.
3. Connect the power cable to controller .
a. If you use the power source from a car or caravan etc, use the cigarette
lighter adaptor to connect the power to controller.
b. Otherwise use a suitable 12 Volt DC adaptor to connect the power to
controller.
4. Connect between the right port of the antenna, which located at the rear of
the main unit, to the receiver using receiver cable.
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will flash twice.
3. Wait until "HOME State" light & one "Satellite LED" light, which you set
previously or the first satellite in the controller (Turksat), remain solid on.
4. Select the desired satellite using the "UP/DOWN" buttons, then press the
"OK" button to select.
5. The satellite LED light will start to flash, wait until it stays solid on.
6. When the satellite LED light stays solid on, the selceted satellite has been
located and a signal can be seen on the satellite TV.
Car / Caravan assembly instructions are described in detail and illustrated,
is attached separately.
MOBILSAT-1 system automatically returns to the HOME position when
the vehicle is moving faster than 10 km / h.
The prerequisite is that the GPS receiver is stable.
To be safe, you should always bring the plant to the HOME position
before starting their vehicle.
Purchase Power Adapter separately from us, or if you purchase it on your
own, purchase ONLY 18V / 3.3A which is certified.
Description