Basic Components - Airthink Bed Cleaner Benutzerhandbuch

Upside
1. Power button
2. Handle
3. Dust container
4. Air outlet
5. Vibrating Control Touch Button;
On, Off
6. Suction Power Control Button;
Turbo, Normal, Weak
Bottom
1. Punch Taps
2. UV Light Lamp
3. Air Inlet
4. Front Wheels
5. Brush Roller
6. Plate Lock
7. Safety Sensor
8. Rear Wheel

BASIC COMPONENTS

UV vacuum cleaner (1), soft brush (2),
Hepa filter (3).
HOW TO USE THE VACUUM CLEANER
1. Plug into an electrical outlet.
2. Press power button around 2 sec.
3. Start normal vacuum suction and vibra-
tion with UV light on.
4. Touch the suction power button to ma-
nage vacuum.
5. Touch the suction power button one
more time to expect higher or less va-
cuum energy up to cleaning objects. The
germicide UV light can be used to sterili-
ze germs, mold, dust mites, and bacteria.
Turbo power is good for thick fabric cloth
as blankets, beds, and cushion pillows.
UV light without vacuum function is very
useful for you to clean the slight fabric clo-
th such as tablecloth, handkerchief, baby
crumb catcher cloth, and curtain.
6. Touch the vibration button if you don't
want to use punch function. This purpose
is for the appliance to avoid vibration noi-
se when cleaning a table, desk, or hard-
board furniture.
7. Press power button around 2 sec to
stop all operation and unplug power cord
from the wall outlet.
8. Store your vacuum cleaner indoors in a
cool, dry area.
HOW TO CLEAN DUST CONTAINER
1. Pull the dust container to remove from
the cleaner with using your fingers.
2. Empty dust from the container.
3. The dust container can be washed in
lukewarm water. Do not use strong deter-
gents. Ensure that the dust container is fu-
lly dry before putting back on the vacuum
cleaner.
NOTE: The filters are not washable. Do
not attempt to wash with water.
HOW TO CLEAN FILTER
1. While holding the dust container in one
hand, remove the inner and outer filter
with your other hand by grasping the pu-
ll-tap on top of the outer filter with your
fingers.
2. Remove the dust filter cover and clean
the filter units with a soft brush.
3. Put the filter units back into the dust
container.
NOTE: Make sure you insert the filter units
in the correct way.
HOW TO CLEAN BRUSH ROLL AND UV
LIGHT LAMP
1. Loosen the locks to detach the bottom plate.
ENGLISH
9