Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BH 2000/1H Originalbetriebsanleitung

6.6 Towel holders
You can pre-warm and dry towels on the towel
holders. Please make sure that the air outlet at the
bottom of the heater housing is not obstructed.
Do not overload the towel holders. They are desi-
gned for a maximum load of 2 kg each.
6.7 Overheating guard
In case of excessive heating, the heat output or
the equipment will shut down automatically. If this
occurs, turn off the equipment, disconnect the
mains plug and wait a few minutes for the equip-
ment to cool. After eliminating the cause (e.g. a
covered air grille), the equipment can be switched
on again. If the overheating guard triggers repea-
tedly, please contact ISC GmbH.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
7.1 Cleaning
•
Before carrying out any cleaning and main-
tenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
•
Maintenance and repair work may only be
carried out by an authorized electrical servi-
cing contractor or ISC GmbH.
•
Check the power cable at regular intervals
for signs of defects or damage. A damaged
power cable may be replaced only by an elec-
trician or ISC GmbH in compliance with the
relevant regulations.
•
Use a damp cloth to clean the casing.
•
Remove dust with a vacuum cleaner.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 21 -