Gmini GM1509 Melisa Bedienungsanleitung Seite 20

8-PLACEMENT OF THE TRAY – 7
Put your hand under the tray where a button for positioning of the tray is located (7) and
push it towards you. Mount the tray on the arm rests and push it towards the back rest (7a).
The tray can be adjusted in three positions. Make sure that the warning triangle is not
visible. If the triangle is visible, the tray has been mounted incorrectly. To mount the tray
correctly, repeat the previous steps. When the tray is placed correctly, there should be an
audible click of the safety.
WARNING: Always make sure to push the tray far enough into the chair. The numbers on
the upper part of the arm rests show the position of the tray. NEVER use the tray if the
symbol of a warning triangle is visible. Before each use, check safety of the tray by pulling it
slightly outwards.
9-REMOVAL OF THE TRAY – 8
To remove the inner part of the tray (8), pull the clip
located on the inner side of the tray outwards and lift the
tray and pull it up. This will release the clip.
To put the inner tray back, push the clip until the tray fits
back into place.
10-STORING THE TRAY ON THE REAR LEGS – 9
15-1109_Jidelni_zidle_navod.indd 20
If the tray is not used, it can be hung on the rear legs of the
chair (9).
Place the tray on the rear legs, as shown. There are
stoppers on the rear legs to hold the tray. After placing the
tray on the stoppers, push the tray down so that it fully
slides into the grooves. To remove the tray, pull it up and
remove it from the stoppers.
9.11.2015 15:54:25