Operation; Troubleshooting; Specifications - Somogyi Home FK28 Bedienungsanleitung

Caution: Risk of electric shock! Do not attempt to disassemble or modify the unit or its accessories.
In case any part is damaged, immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the
manufacturer, its service facility or similarly qualified personnel.
Meaning of symbol on appliance: Do not cover!
Covering the unit can cause overheating, fire or electric shock!
FEATURES
ceramic fan heater for warming the air of indoor premises • combo LCD • controllable with touch buttons or by remote controller • 1000 / 2000 W output • operating modes: cold, warm and hot air •
optional thermostat control • switchable oscillation • timing for switch off • overheating protection • tip-over protection • recessed carrying handle
STURCTURE (figure 1.)
1. cold air inlet • 2. removable filter • 3. compartment for remote controller • 4. hot air outlet • 5. recessed carrying handle • 6. main switch • 7. tip-over protection switch • 8. power cable • 9. screws
Control panel
10. oscillation • 11. timer / thermostat • 12. temperature and operating mode display • 13. heating level selection • 14. on/off switch
Remote controller
15. on/off switch • 16. temperature setting buttons • 17. heating level selection • 18. oscillation • 19. timer
SETUP
1. Before switching on for the first time, carefully remove the packaging material taking care not to damage the appliance and power cable. Do not use the product if it is damaged in any way!
2. The unit may only be used indoors in dry conditions!
3. Following Figure 3. put the two-part leg together, don't forget to lead the wire out in the middle! Insert the assambled base onto the bottom of the unit and fix with the 4 screws. Lead the
connecting cable backwards!
4. Set the appliance on a stable and horizontal surface. The free flow of warm air must be ensured for proper operation, therefore, please note the minimum installation distances indicated in
Figure 2. Do not locate the appliance directly below a wall outlet!
5. Verify that the unit's main switch (6) is in OFF „0" position!
6. Plug the unit's standard grounded AC power cable into a grounded wall outlet!
7. Insert 1 pc CR2025 button battery to the remote controller! Take care of the right polarity! This completes the setup of the appliance.

OPERATION

The appliance can be controlled using the remote controller or via the control panel buttons.
After connecting it to the power network, power it on using the main switch (6).
The unit will emit a short beep, the current temperature of the room will indicated on the display (°C).
Functions of the buttons on the unit:
With button 14 you can turn on and off the unit. Fan will start working by switching on, and the graphic of current operation mode will be shown on the combo LCD. After switching off the unit, the
fan will work 30 seconds more, while the appliance count back. Do not cut off power until the appliance stops on its own, because doing so will damage it.
With button 13 you can select the low (
With button 11 you can control the turn-off timing and the thermostat.
You can set the timer in 0,5 hour increments by pushing it, from 0,0 up to 7,5 hours.
When the display returns to display of temperature, keeping the button down for 3 seconds, it will change to thermostat operating mode. In this stage, you can set the target temperature from 18 –
45 °C, only step by step. The inbuilt thermostat will choose the conforming heating level, or it will switch to fan level, if the room temperature has reached the target.
With the 10 button you can switch on and off the 75° oscillation of the appliance.
Remote control button functions
15: See unit's 14 button
16: Thermostat setting buttons
17: See unit's 13 button
18: See unit's 10 button
19: Turn off timing from 0,0 to 7,5 hours.
In the event of overheating, the overheating protection function will switch off the unit, for example, when the air inlets and outlets are covered. Power off the unit by unplugging it from the electric
outlet. Allow the appliance to cool (for at least 30 minutes). Check whether the air inlets and outlets are obstructed or not, and clean them if necessary. Switch on the unit again. If the overheating
protection activates again, power off the unit by unplugging it from the electric outlet and contact the service facility.
A tip-over protection switch on the bottom of the appliance turns it off if it would topple over. In such cases remove power from the appliance by pulling out the power plug then stand the
appliance upright and reinstall it only afterwards according to the section entitled SETUP.
CLEANING & MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
1. Switch off and power off the unit by unplugging it from the electric outlet before cleaning.
2. Allow the appliance to cool (for at least 30 minutes).
3. Clean the air in- (1) and out (4) lets with vacuum cleaner. You can remove the filter at the air inlet opening, and wash it with clean water. Place only dry filter back into the appliance.
4. Use a slightly moistened cloth to clean the unit's outer surface. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the appliance.

TROUBLESHOOTING

Cause
The unit doesn't heat in thermostat operating mode.
The unit doesn't heat.
The overheating protection activates frequently.
The unit does not respond to the remote controller's signal.
Waste equipment must not be collected separately or disposed of with household waste because it may contain components hazardous to the environment or health. Used or waste
equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of product at a facility
specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself. If you have any questions, contact the local
waste management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising.
DISPOSING OF ALKALINE AND RECHARGEABLE BATTERIES
Batteries, whether alkaline or rechargeable, must not be handled together with regular household waste. It is the legal obligation of the product's user to dispose of batteries at a
nearby collection center or at a retail shop. This ensures that the batteries are ultimately neutralized in an environment-friendly way.

SPECIFICATIONS

power supply:. . . . . . . . . . 230V / 50 Hz
rated power:. . . . . . . . . . . 1000 / 2000 W
max. power: . . . . . . . . . . . 2000 W
IP protection: . . . . . . . . . . IP20: Not protected from ingress of water!
size of heater: . . . . . . . . . 16x76x11 cm, diameter of base: 26 cm
weight: . . . . . . . . . . . . . . . 2,4 kg
length of power cable: . . . 1,35 m
noise level:. . . . . . . . . . . . 60 dB(A)
) or high ( ) level of heating.
Solution
Check the settings of the thermostat, this might not be a malfunction.
Check the mains switch.
Check the power supply.
Check the tip-over protection switch.
Clean the appliance.
Check the remote controller batteries.