Connect The Scanner To Your Vehicle - Tecnotest EZ-scan 4000 Bedienungsanleitung

__________________________________________________________________________ EZ-SCAN 4000
Adjust the Display Contrast and Backlight
The contrast on your EZ-SCAN scanner can be adjusted for easier viewing under
different lighting conditions. Note, if scanner is left in direct sunlight the Display can
turn completely black. Should this happen, put the scanner in a cool dark place for
approx. 10 to 15 minutes. The display should return to normal.
•
To adjust the contrast of the screen press CONFIG key.
•
Use the arrow keys until 2-System Config is displayed, then press ENTER.
•
Use the arrow keys until 3-Contrast Adjust is displayed, then press ENTER.
•
Use the and
•
Use the and
•
The MON key will turn the backlight off. The default position is ON and can be left
that way, however it will lessen the life of your batteries.
•
Press the CONFIG or ENTER key to save settings and return to the Opening
screen.
NOTE:
Not all Scanners support this feature.
2.4 -

Connect the Scanner to Your Vehicle

The EZ-SCAN Scanner communicates with the computer and sensors in your vehicle
through a special connection cable. The scanner cable is plugged into a connector on
the top of the scanner, and into a computer interface connection in your vehicle.
All 1996 and newer vehicles use one cable, the OBD-II Generic Connector.
•
Locate the vehicle computer connection:
On OBD-II vehicles, the connector is usually located under the drivers side of
the dashboard. On some vehicles, the connector is located behind the kick
panels, ashtray, or radio.
OPERATING INSTRUCTIONS
arrow keys to adjust desired screen contrast (Fine adjustment).
arrow keys for course adjustment.
OBD-II Generic Connector (Yellow)
This standardized cable is used to scan
1996 and newer Domestic, Asian, and
European vehicles.

39