Werbung
Verfügbare Sprachen
Verfügbare Sprachen
assEMbLy insTrUCTiOns
Visserie et pièces
read all assembly instructions completely before attempting assembly.
see parts list on page 2 for names and pictures of parts. identify all components and
hardware.
1. Install leg as shown in Figure 1 to top Frame and secure with 1/4» - 20 x 1-3/4» bolt
and 1/4» lock nut . Insure that Snap Pin is facing out and securely latches in the open and
closed positions.
do not over tighten. Repeat on remaining three legs.
note: the two legs with the additional 4 holes need to be mounted on the same end of the
top Frame.
2. Place top frame upside down on your workbench or work surface. Openthe legs by de-
pressing the snap pins and pivot the legs into the open
position.
3. Install 1-1/4» tube Plugs into the bottom of all four legs, as shown in Figure 2. Return
unit to upright position.
4. Install the Outrigger Supports into the top tube as shown in Figure 3.
5. Install (4) 5/16» - 18 3-Point Knobs into the threaded holes in the top
tubes and Outrigger Supports .
6. Install Support t's into the ends of the Outrigger Supports . Figure 4.
7. locate the machine mounts (Part# 3042). carefully review Figure 5. note the location of
the spring mounted handles; these should be positioned to the rear of the saw as shown.
this allows for easier installation and removal of the saw.
8. Attach the (2) machine mounts to the saw using 5/16»-18 x 2-1/2» carriage bolts at each
saw mounting point. See Figure 6. From the bottom, pass the carriage bolt through the slot
in the machine mount, through the mounting hole and secure with 5/16» flat washer , lock
washer and nut. hand tighten only.
9. carefully lift the saw and place onto the miter saw stand. be sure the hook
end of the machine mount locks under the top tube as shown in Figure 7. the spring loaded
handle should lock under the opposite top tube as shown in Figure 8.
10. Slide the saw forward or back along the machine mount to best balance the saw on the
stand. Secure the saw by tightening the carriage bolts installed in Step 8.
9
Werbung
