Setting Date And Time; Offset Temperature; Selection Of Temperature Display/Humidity - Alpha IP WTHP 61001-series Handbuch

Operating modes and configuration
way when it must start the heating/cooling process in order to provide the stored
temperature exactly at the defined heating times.

6.1.6 Setting date and time

1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
wheel.
3. Set the year, month, day and time by turning/pressing the setting wheel (E)
and conform each.

6.1.7 Offset temperature

Since the temperature is measured at the room control unit Display, it may be warm-
er or cooler in another position on the room. This deviation is corrected using the
offset temperature (up to ±3.5 °C).
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
ting wheel.
3. Turn the setting wheel and confirm the desired offset (max. ±3.5 °C) by shortly
pressing the wheel.

6.1.8 Selection of temperature display/humidity

The display alternately shows the actual or the set temperature as well as the hu-
50
" and confirm the selection by shortly pressing the setting
" and confirm the selection by shortly pressing the set-