Logitech Pilot Schnelle Startanleitung

English Deutsch Français
Logitech
Getting Started Guide
1
Important Safety Information
Before using your mouse, please read the Comfort Guidelines that come with your product.
2
Connect the Mouse
1. For installation on a PS/2 mouse port, turn off
the computer. Connect the mouse cable to the PS/2
mouse port on the computer, then turn on your system.
2. For USB-port installation (Windows
or Macintosh
PS/2 adapter. Connect the mouse cable to the USB port
on the computer. For Windows, you may be prompted to
insert the Windows software CD. Insert this software CD into the computer's CD-ROM drive when asked to do
so, then follow the on-screen instructions.
3
Install the Software
1. For PCs, start Windows
then follow the on-screen instructions. (If Autorun is not enabled, select Run from the Start Menu on
the Taskbar. Next, type D:\Setup.exe, where D: is the designation of the CD-ROM drive.)
2. For the Macintosh
into the computer's CD-ROM drive, find the Installer icon in the appropriate language folder,
double-click the icon, then follow the on-screen instructions.
© 2000 Logitech. All Rights Reserved. Logitech, the Logitech logo, and the Logitech products referred to herein are either the trademarks or the registered trademarks of
Logitech. All other trademarks are the property of their respective owners. Logitech assumes no responsibility for any errors that may appear in this manual. Information contained
herein is subject to change without notice.
Part Number: 622807-0914
Italiano Español
Dansk Norsk
Pilot Wheel Mouse Optical
®
OS 8.6 or higher required) remove the
®
, insert the Logitech
®
, start the Macintosh operating system, insert the Logitech software CD
®
Português Nederlands Svenska
Suomi Ελληνικά По-русски
98 or higher
®
USB Port
software CD into the computer's CD-ROM drive,
®
Magyar Česká verze Po polsku
PS/2 Port PS/2 Port Adapter
®