Cleaning The Shaver - Blaupunkt MSR901 Bedienungsanleitung

MSR901
1. Shaving head
2. Shaving-head housing
3. Button opening the shaving-head
housing
4. Heads
4a. rotating shaving head
4b. body shaving head
4c. hair-clipper
4d. nose trimmer
4e. brushes
4f . massager
USING THE SHAVER
Attach the shaving head to the device body.
Turn on the shaver with the switch.
If using the shaver with the rotating head, move the shaver across the skin's surface with circular
motions.
If using the shaver with the foil head, move the shaver across the skin's surface while gently tightening
it.
Clean the shaving head with a brush after each use.
The device can be used for both wet and dry shaving. When using shaving foam or gel, rinse the shaver
regularly with water to prevent the shaving head from "clogging".
Note: each shaver requires the face and the facial hair to adapt to the blade system applied. The first
shave might not be perfectly precise, and your skin can become irritated. The adjustment period can
last up to 3 weeks.

CLEANING THE SHAVER

Make sure that the device is switched off and not connected to the charger.
Clean the shaving foil and/or the blades each time after using the shaver. Use a brush for this purpose.
The blades can be rinsed under running water.
Perform thorough cleaning regularly. To do this, press the button opening the shaving-head housing.
Wash out all the clippings from the inside of the device. (as shown in the Figure) Remove and clean
each blade-set head.
Note: the blades must be replaced in the heads from which they have been removed (the blades adjust
to the head individually, and, if they are used in a different head, their effectiveness can be decreased,
and in an extreme situation damaged).
After cleaning the heads, place them along with the blades in the housing (pay attention to the
notches and grooves) and lock them in place.
FACIAL-HAIR CLIPPING
Fit the hair-clipping head onto the body of the device. Activate the shaver with the switch. Slowly
move the device over your hairs. It is recommended to direct it "against the grain", i.e. in the direction
opposite to the hair growth.
USING THE HAIR CLIPPER
Fit the hair-clipping head onto the body of the device. Choose the appropriate comb head (the hair-
length-cutting mark is visible on the side of the comb head). Fit the comb head onto the hair clipper.
Activate the hair clipper with the switch. Slowly draw the device over your hair. It is recommended to
direct it "against the grain", i.e. in the direction opposite to hair growth.
Note: take care to remove the excess cut hairs from the comb head.
5. Switch
6. Display
7. Charging socket
8. Charging station with socket space
9. Power cable with transformer (can be
connected directly to shaver and charging
station)
4