Safety Warnings; Installation Instructions; Use And Maintenance - Glem GTH32K Betriebsanleitung

GENERAL
Carefully read the contents of this leaflet since it provides
important instructions regarding safety of installation, use and
maintenance.
Keep the leaflet for possible future consultation. All the op-
erations relating to installation (electrical connections) must
be carried out by specialised personnel in conformity with the
regulations in force.

SAFETY WARNINGS

It is recommended to use flat-bottom pans with a diameter equal
to or slightly larger than that of the heated area. Do not use pans
with a rough base to prevent scratching the heat surface of the
cooktop (Fig.3).
This appliance is not suitable for use by children or persons
requiring supervision. Do not let children play with the ap-
pliance.
Important
- Avoid spilling liquid, therefore to boil or heat liquids, reduce
the heat.
- Do not leave the heating elements on with empty pots and
pans or without receptacles.
- When you have finished cooking, switch off the relevant heating
element with the control indicated below.
ATTENTION:
- Steam cleaners must not be used.
- If the surface is cracked, switch off the appliance to prevent
electric shock.
- This appliance is not intended for use by young children or
infirm persons without supervision
- Young children should be supervised to ensure they do not
play with the appliance

INSTALLATION INSTRUCTIONS

These instructions address specialised installers and serve as a
guide for installation, adjustment and maintenance in conformity
with the laws and regulations in force.
· Positioning (Fig.1)
The domestic appliance is designed to be built into a worktop as
illustrated in the specific figure. Apply sealant around the entire
perimeter (cut-out dimensions Fig.1B).
Fix the domestic appliance on the worktop by means of the 4
brackets provided, taking the thickness of the worktop into ac-
count (Fig.1A). If the lower part of the appliance, after installation,
is accessible via the lower part of the cabinet then it is necessary
to mount a separator panel respecting the distances indicated
(Fig.1C). If the appliance is installed with an oven underneath
then the separator is not necessary.
· Electrical connections (Fig.2)
before making the electrical connections, check that:
- the ground cable is 2 cm longer than the other cables;
- the system ratings meet the ratings indicated on the identifica-
tion plate fixed on the lower part of the worktop;
- the system is fitted with efficient earthing compliant to the laws
and regulations in force.
Earthing is obligatory by law.
ENGLISH
If the appliance is not fitted with a cable, use type:
"H05V2V2-F" for a power level of up to 6400 Watts. The cross-
section of the cable should be at least 2.5 mm², or 4 mm² for
greater power levels.
The cable should never reach a temperature which is 50°C above
the temperature of the room in which it is installed.
The appliance is designed for permanent connection to the
electricity supply and should therefore be fitted with an omni-
polar switch which has a minimum opening of 3 mm between
contacts. The switch should be suitable for the charge indicated
on the appliance data plate and must conform to all current
legislation (the yellow/green earth wire must not be interrupted
by the switch).
The omnipolar switch must be easy to reach once the installation
process has been completed.

USE AND MAINTENANCE

· Maintenance
Remove any residues of food and drops of grease from the
cooking surface using the special scraper supplied on request
(Fig.5)
Clean the heated area as thoroughly as possible using SIDOL,
STAHLFIX or similar products and a cloth/paper, then rinse with
water and dry with a clean cloth.
Using the special scraper (optional) immediately remove any
fragments of aluminium and plastic material that have unin-
tentionally melted on the heated cooking area or residues of
sugar or food with a high sugar content (Fig.5). In this way, any
damage to the cooktop surface is prevented.
Under no circumstances use abrasive sponges or irritating chemi-
cal detergents such as oven sprays or stain removers.
· Use
Set the power desired by turning the control knobs clockwise
to the maximum power.
· To activate the double zone, turn the knob in a clockwise
direction, until it has reached the maximum power position.
At this point, keep on turning it in a clockwise direction, until
it has reached the "0" position (the point at which it originally
started).
If the knob is not fitted with a return spring, turn it in a clockwise
direction again, until you hear a click (approximately 90°). Then
turn the knob in an anticlockwise direction, returning it to the
maximum power position.
To deactivate the double zone, turn the knob in an anticlockwise
direction.
· Indicator lights (fig. 4)
- If your product is fitted with the voltage indicator light (Fig. 4A),
when lit this indicates that at least one element is operating.
When the indicator light is on, the temperature on the hob
surface exceeds 50°C (fig. 4b - 4c).
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE
WARNINGS.
- 7 -
GB