Fleck Electronic SE Bedienungsanleitung Seite 10

2 - PROGRAMMING
Caution: the programming has to be done only by the installer for the valve setting of
parameters. The modification of one of these parameters could prevent the good
functioning of the device.
To enter the program mode the valve has to be in service. While in the program mode, the valve
will continue to operate normally monitoring all information. The programming is stored in
permanent memory.
To enter in the program mode, push and hold for 5 seconds both buttons
Push the button
Change the option setting by pushing either the buttons
Note: You must pass through all the programming steps and come back in service position to
save the modi-fications that have been done during programming mode.
9
once per display.
System capacity: the capacity is in litres or m
For ex.: 6500 liters
Regeneration time.
For ex. : 02.00 o'clock A.M.
Regeneration day override (maximum number of day before a regeneration
cycle must occur). For ex.: 7 Days.
.
or .
3 .
ELECTRONIC SE
E
N
G
L
I
S
H