Height Adjustment Of Brush; Angle Adjustment Of Brush; Technical Specifications; Troubleshooting - Texas HS619TG Bedienungsanleitung

Height adjustment of brush

When the brushes become worn it might be necessary
to adjust the proximity of brushes to the working
surface. To adjust the height of the brushes follow
figure 7:
1. Remove the lock pin
2. Lift the front of the machine to free the brush
and pull the supporting wheels out.
3. Remove or add the spacer ring
(1 ring = approx. 5 mm)
4. Install support wheels, remove / add spacer
ring, fasten with locking pin.
(Hint: Complete one wheel at a time)

Angle adjustment of brush

The brush can be pivoted 20 degrees to either side.
This is done by pushing the swing handle down,
turning the brush and releases the handle so the
detent clicks into place.
The swing handle is shown on Figure 6, H.

Technical specifications

Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush
(positions)
Gears (forward/reverse)
Tire size
Tire pressure (psi)
Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush
(positions)
Gears (forward/reverse)
Tire size
Tire pressure (psi)
HS619TG HS650TG HS650TGE
610 610 610
600 600 600
72.5 72.5 73
350 350 350
3 3
3+1 3+1 3+1
13 x 13 x
13 x 4.10
4.10 4.10
24 24 24
HS710TG HS710B HS710TGE
710 710 710
700 700 700
74.5 74.5 75
350 350 350
3 3
3+1 3+1 3+1
13 x 13 x
13 x 4.10
4.10 4.10
24 24 24

Troubleshooting

Problem Solution
The engine won't start:
The engine runs unevenly:
If the brush will not run:
If the machine will not run:
If the machine does not sweep effectively:
3
3
15
1. Check sparkplug.
2. Check that the spark plug cap is fitted
correctly.
3. Check if the motor is equipped with an
ignition switch.
(It must be activated)
4. Check if the motor is equipped with a
fuel valve.
(It must be activated)
1. Check that the choke has been
released.
2. Check fuel for impurities.
1. Check that the clutch cable is adjusted
correctly (figure 5).
2. Check that the belt is tight.
1. Check that the clutch cable is adjusted
correctly (figure 5).
2. Check the belt.
1. Check the distance between the brush
and working surface.