Assembly; Operation; Operation Safety Zone - Texas HS619TG Bedienungsanleitung

Assembly

The sweeper is almost ready assembled from the
factory. Only a few items remain to be assembled:
Actual model may vary from the illustration shown
Check the tire pressure on both wheels before use.
Correct tire pressure is
24 psi/1.7 bar. Fig 8.
Use of machine with too low tire pressure,
can damage the tires!
Handy Sweep - all models
1.
Remove the bolts from the base unit then
mount the handle bar and fix the bolts
See figure 3.
2.
Mount the gear shifter rod to the bracket as
shown in figure 4.
3.
Pull the cables up to the clutch handles.
Separate the metal parts by turning them
apart. Mount the part with the hook onto the
clutch handle. Assemble the 2 metal parts and
turn it until the cable is tight. See figure 5.
4.
Mount swing handle with enclosed bolt and
nut. Figure 6.
Only HandySweep 710 models
5.
Mount the brush on each side following the
assembling method 1 or method 2.
See fig 9 (M1 or M2)
Explanation to figure 9, A1:
A. Brush
B. Spacer cup
C. Bracket
D. Bolt
6.
Mount the guard using the enclosed bolt,
washer and nut. Follow the step 1-5 in figure
10. NB: The sideguards has to be mounted
under the main guard.

Operation

Read the instruction manual for the engine,
before use
Before using the machine, remove bigger objects from
the vicinity. Bigger objects can damage the sweeper.
Also check that all bolts are tightened.
Control oil level before starting the engine.
See attached guide
Start the engine:
1. Open the fuel tap.
2. On a cold engine open the choker.
Note: By a hot engine choke is not required.
3. Turn the throttle cable to "start" position.
4. Pull the recoil starter gently until you feel
resistance in the rope. Then pull quickly and
energetic. Do not at any time let go of the
recoil starter but glide it gently back and pull
again.
5. 230V electric starter (HS650TGE / HS710TGE
only). Plug the cord into electrical outlet and
press the start button. After the engine is
started remove the plug from the socket.
6. Regulate the choker until the engine is running
smoothly.
Stop the engine:
1. Set the throttle to minimum/stop.
2. Turn the fuel tap to the"off" position.
Gear shifter
3 different forward gears and 1 reverse gear can be
selected. See figure 12.
Always release the clutch handle before
Clutch handle A - Forward and Reverse.
To operate the black clutch handle A in figure 11,
activate the handle, so the sweeper will drive forward
or backwards. To change gear, release the clutch
handle and chose the desired gear with the gear
shifter.
Pay attention while reversing. It is important that the
area is cleared, for any obstacle before reversing.
Never reverse the sweeper against a wall, tree or any
other fixed obstacle.
Clutch handle B - Activation of brush.
To operate the black brush handle B in figure 11, push
down the handle and it activates the brush.
The sweeper is equipped with a "dead man's handle",
once released the brush and drive will stop
immediately.

Operation safety zone

Do not leave the operation safety zone marked in
figure 13, while working with the machine. If it is
necessary to leave the operation zone, for example to
readjust the rotary brush or to attach an accessory,
first stop the engine.
14
changing gear!