Intermec SR61 Kurzanleitung Seite 4

Connecting the SR61 to a Host Device
You can connect the SR61 to these host devices:
• Intermec computer that is Bluetooth-enabled
• PC with a USB Bluetooth adapter (P/N 203-771-xxx) or an
RS-232 Bluetooth adapter (P/N 203-768-xxx)
• Other Bluetooth-enabled devices that support Serial Port
Profile (SPP)
To connect to an Intermec computer
1 On your PC, start EasySet v5.4.1. Make sure that SR61 is
selected as your product.
2 From the EasySet commands window, select Data
transmission settings > Bluetooth Parameters > connect/
disconnect.
3 Double-click compose BT address.
4 Enter the Bluetooth address of your Intermec computer and
click OK. The bar code appears on the setup sheet.
5 Scan the bar code onscreen with the
SR61xA or SR61xV, or print the bar code
setup sheet and scan the bar code. The
SR61 beeps once, the green status light
flashes once, and the blue Intermec
Ready-to-Work™ indicator starts blinking.
On your Intermec computer, the Authen.
Request dialog box appears.
6 In the Enter PIN field, enter the default PIN (0000) and
select OK. When the SR61 connects to your Intermec
computer, the SR61 emits a series of beeps from low to high,
and the blue Intermec Ready-to-Work indicator turns on and
stays on. The SR61 is ready to scan data.
For more information, see your Intermec computer user's
manual.
To connect to a PC with a USB or RS-232 Bluetooth adapter
1 Install the USB or RS-232 Bluetooth adapter.
2 Connect and pair your SR61 to your host PC.
4