Problems And Troubleshooting - Haus & Luft HL-KP-10 Bedienungsanleitung

PROBLEMS AND TROUBLESHOOTING

PROBLEM
AIR CONDITIONER DOES NOT WORK
POOR COOLING PERFORMANCE
LOUD NOISE
COMPRESSOR DOES NOT WORK
E1 ERROR CODE ON THE DISPLAY
E2 ERROR CODE ON THE DISPLAY
APPENDIX
SAFETY FUSE RATINGS
Type – 5ET or SMT
Voltage – 250V
Current – 3.15A
AIR CONDITIONER SCHEMATIC DIAGRAM
Compressor
HL-KP-10_instrukcja_v03.indd 25
CAUSE
a. No power
b. The "Full" indicator light comes on
c. The room temperature is too low.
d. The room temperature is below the
cooling temperature setting.
a. The air inlet/outlet is obstructed.
a. The air conditioner does not stand on
a level floor.
a. The automatic overheating
protection feature is on.
a. Incorrect temperature of the
appliance's circuits
a. Incorrect room temperature
Condenser
SOLUTION
a. Plug the appliance to the mains and
turn it on
b. Drain the condensate.
c. The air conditioner should be
operated between 7°C and 35°C
d. Change the temperature setting.
a. Remove the obstruction.
a. Move the air conditioner to a level
floor, which may reduce the noise.
a. Wait 3 minutes for the compressor
to cool down and then restart the
appliance.
a. Turn off the appliance, wait for it to
cool down and turn it on again.
a. Wait until the temperature is in the
room temperature range.
Capillary
Evaporator
25
13.12.2018 07:53:59