Parts Description; Before The First Use; Cleaning And Maintenance - Kiwi KAH-6612 Bedienungsanleitung

PARTS DESCRIPTION

1. Water tank
2. Base
3. Touch panel
4. Filter
AC220-240V, 50/60Hz, 20W

BEFORE THE FIRST USE

• Take the appliance and accessories out the box. Remove the stickers, protective foil or plastic
from the device.
• Before using your appliance for the first time, wipe off all removable parts with a damp cloth.
Never use abrasive products.
• Put the power cable into the socket. (Note: Make sure the voltage which is indicated on the
device matches the local voltage before connecting the device. Voltage 220V-240V 50/60Hz)
• Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around
the device. This device is not suitable for installation in a cabinet or for outside use.
USE
• It is recommended to use the unit under temperature of 5-40 °C and a relative humidity less
than 80%RH.
• Take the water tank out off the unit, remove the water tank cover, and fill the tank with clear
water not over 40 oC then put back the cover.
• Check the water basin and make sure it is clean, then put the tank onto the base unit carefully.
• Connect the power plug and switch on the unit by turning the control knob to the right, the
main connection lamp will illuminate. The unit starts working. The control knob can be used to
control the humitity output.
• NOTE: never switch on the unit when there is no water in the water basin.

CLEANING AND MAINTENANCE

• Use cold boiled water or distilled water.
• Change the water in water tank weekly to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the
unit is not in use.
How to clean the filter system
• Clean the ceramic balls after use for 1000L water regularly.
• Take off the water tank and turn off the filter system from the water tank.
• Put the filter system into the white vinegar for about 10 minutes.
• Take the filter system away from the white vinegar; shake for several times and rinse it with
clear water. Make it dry. Pack it into a polybag.Keep it in a cool and shady place.
How to clean the base and water tank
• Put a few drops of vinegar on the surface of the base and water tank and wait for 2-5 minutes.
• Brush off the limescale rinse the inside of the base and the water tank with clean water.
kah-6612 User Manual
3
2
3
4
1