Audio Pro LIVING LV2 e Bedienungsanleitung Seite 9

trOuBleshOOting
the speakers play BaCk at diFFerent vOlumes
use the zone-volume buttons for the zone that is set on the speakers, adjust the volume up or down with the
remote, and all speakers will be synchronised to the same volume level in the entire zone.
One speaker is On, Others OFF
if one of the speakers is disconnected from the power supply whereas others are connected to the power
supply, the On/Off function may get out of sync. proceed as follows in such cases: switch off the main
power switch on the left speaker. depending on the status, switch on or off the right speaker (main speaker
with receiver for remote control). then switch on the power switch on the left speaker again and start up
the system with the remote control on the right speaker (while doing this, you should play music so that the
speakers are receiving an audio signal).
netwOrk trOuBleshOOting
Is the LED light on the transmitter blue?
if the light is red, try moving the transmitter and receiver closer together. does this turn the led blue?
Are you using more than one TX100 transmitter?
make sure that the tX100's aren't running on the same house Code. if more than one tX100 uses the
same house Code, interference may occur. disconnect one tX100, or change the house Code.
Are you using the same House Code on transmitter and receiver?
make sure the same house Code is set on both the transmitter and the receiver.
How far apart are the transmitter and receiver?
if distance between the transmitter and receiver is too far, the, connection might be lost.
try placing the transmitter and receiver in closer proximity, does this help?
Are there walls between the transmitter and receiver?
if your home has thick concrete walls, or walls of plaster with wire lath, the wireless range will
decrease. try placing transmitter and receiver in the same room, does this help?
Are there more wireless networks in the area?
if there are many wifi networks running in the area, wireless range can decrease. there are useful apps
for iphone/ipad/ipod touch and android to detect local wifi networks, and see which channel might be
crowded. you can also try to change the channel on your wireless router to improve audio pro network
range and your own home network wifi performance. (audio pro network transmits on channel 1, 6
or 11.)
Is your computer connected to the internet via cable or wifi?
the audio pro network can weaken a local wifi network (but not weaken itself). if possible, you should
change channel on your wireless router, the audio pro network transmitts on channel 1, 6, or 11.
Choose a new channel on your router, for example 3, 8 or 13. (in total there are 13 channels on the
2.4 ghz band.) there are useful apps for iphone/ipad/ipod touch and android to detect local wifi
networks, and see which channel might be crowded. if you cannot change the channel on your wireless
router, try connecting computer via ethernet cable instead. does this help?
Are there Bluetooth units active in the area?
shut down all active Bluetooth devices. does this help?
Windows 7 and Mac OS, sound output
when connecting the tX100 transmitter to a computer using windows 7 or mac Os, you need to select
the sound output. go to: system settings, find sound settings, and select usB headset as your sound
output. (In older Windows OS there is no need for this, TX100 will take over automatically as the sound
output device.)