Herunterladen Diese Seite drucken

Kit Contents; Interface Installation - OHAUS RANGER 7000 Bedienungsanleitung

Diskrete i/o-schnittstelle
Vorschau ausblenden Andere Handbücher für RANGER 7000:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
Discrete I/O Interface
INTRODUCTION
This discrete I/O interface Kit is for use with the Ohaus Ranger
When installed, the system software allows the relay to be programmed in a variety of ways.
BASIC APPLICATIONS
Applications include: driving external Over/Accept/Under displays, motor controls for semi-automatic
filling systems, sorting systems, interfacing to industrial PLC systems, etc. The Relay outputs can
also be used as slave relays to drive high power relays in larger systems.
For the setup in each application, please refer to the instruction manual supplied with scale.
Set up the discrete I/O controls as described in the I/O menu section of that manual.
CAUTION: Read all safety warnings before installing, making connections, or
servicing the Discrete I/O PCB. Failure to comply with these warnings could result in
personal injury and/or property damage. Retain all instructions for future reference.

KIT CONTENTS

 Cable Gland
 Connector, 6 Pin

INTERFACE INSTALLATION

CAUTION: THE INSTALLATION AND WIRE CONNECTIONS TO THE DISCRETE I/O
BOARD SHOULD ONLY BE DONE BY AUTHORIZED AND QUALIFIED
PERSONNEL, SUCH AS AN ELECTRICIAN.
WARNING: BEFORE MAKING CONNECTIONS TO THE RELAY TERMINALS,
POWER OFF THE SYSTEM AND REMOVE ALL EXTERNAL AC POWER
CONNECTIONS.
WARNING: WHEN MAKING ANY LINE VOLTAGE CONNECTIONS TO THE
DISCRETE I/O, FOLLOW NATIONAL ELECTRICAL CODE (NEC) OR LOCAL
AUTHORITY WIRING STANDARDS AND SAFETY PRACTICES.
Install the Interface module inside the terminal as shown.
Note: The appearance of your model may be different than that shown.
®
 Connector, 3 Pin
 Cable to mainboard
7000.
 Screws (4)
 I/O PC Board
EN-1

Werbung

loading