Before Operation - Active MS 8400 Bedienungsanleitung

Vorschau ausblenden

Seite von 40

/ 40
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

AIR CLEANER

PRIMER BULB

Be sure the power blower is correctly assembled and all fasteners and fittings are properly secured.

THROTTLE LEVER

Before operating the power blower, release the knob, knove the throttle grip to the position in the illustration, and

tighten knob to secure in place.

When the power blower is strapped to the back of the operator, the throttle lever of is located on the tube.

CAUTION!

1. Shutting Engine Off

Before shutting the engine off, allow it to idle for a short while.

• Never stop the engine by closing the choke.

• Never stop the engine during operation while running above idle spped.

2. Transporting and Storage

• Shut off the engine and allow it to cool before transporting or storing the unit.

• Do not put the unit on dry grass or near any flammable object unless the engine is cold or cooled

down.

The lowest position of lever is "STOP setting, and the highest position is the "FULL THROTTLE" setting.

FUEL: MIXING GASOLINE AND OIL

CAUTION! The engine used on this Backpack blower is of a 2-cycle design. The internal moving parts of the engine, i.e., crankshaft bearings, piston pin

bearings and piston to cylinder wall contact surfaces, require oil mixed with the gasoline for lubrication. Failure to add oil to the gasoline or failure to mix

oil with the gasoline at the appropriate ratio will cause major engine damage which will void your warranty. For your fuel premix, only use quality oil

designed for 2-cycle air-cooled engine.

FUEL; MIXING GASOLINE AND OIL

CAUTION! Never use a mixing ratio less than 50:1 of the oil package mixing instructions. Ratios

less the 50:1, (for example, 60:1, 80:1, 100:1), reduce the amount of lubrication to the internal

moving parts of the engine and can cause damage.

MIXING INSTRUCTIONS: Always mix fuel and oil in

a clean container approved for gasoline. Mark the

container to identify it as fuel mix for the Backpack

Blower. Use regular unleaded gasoline and fill the

container with half the required amount of gasoline.

Pour the correct amount of oil into the container

then add the remaining amount of gasoline. Close

the container tightly and shake it momentarily to

evenly mix the oil and the gasoline before filling the

fuel tank on the Backpack Blower.

NOTE:

1. Never mix gasoline and oil directly in the Backpack Blower fuel tank.

2. Do not use automotive motor oil. This type of oil does not have the proper additives for air-cooled, 2-cycled engines and can cause engine damage.

English

RECOIL STARTER

ENGINE

BLOWER HOUSING

BAND

CLAMP

FLEXIBLE PIPE

FUEL TANK

RETURN PIPE

HIP BELT