Important Instructions - SOLIS 851 Bedienungsanleitung

SOLIS Plate warmer
Please retain these instructions for later use

Important instructions

- Read the information carefully.
- The appliance must be connected only to the stipulated mains voltage.
- Do not operate the plate warmer unsupervised.
- Do not pull on the cable, twist or bend it sharply.
- Do not pierce with needles!
- The mains cable should not be exposed to moisture.
- Do not use the plate warmer when it is wet.
- Check the appliance frequently for signs of wear or damage. If such signs are in evidence
or if the appliance has been used incorrectly, it must be returned to the manufacturer or
dealer before being used again.
- If the mains cable is damaged, it should only be replaced at a repair workshop approved
by the manufacturer, as special tools are required for the repair.
- Repairs to electrical appliances must be carried out only by trained personnel.
Improper repair could result in considerable risks for the user.
- When not in use, always unplug the appliance from the mains. We recommend storing it
in a dry place with no weight placed on it.
Please retain these instructions for later use
The surface of the plate warmer clearly marked as the "lower side" should be placed
on the table.
The plate warmer is folded like an accordion. The plates should be inserted from both
open sides between the heating elements; it should, however, be observed that the
middle parts of the warmer should be given preference when putting in the plates.
It is possible to heat 1-2 plates in each layer. When the warm plates are taken out,
after 15-20 minutes, it is imported to remove the plug at the same time.
Should the plate warmer be put on a polished woode surface, it is advisable to use
a protection pad in order to prevent damage which could be caused by heat. Whilst
in use the plate warmer should be under constant supervision.
Disposal: In conformity with Directive 2002/96/EC on waste electrical and
electronic equipment (WEEE), at the end of its life the unit should be taken to an
electrical appliance collection point for its environmentally friendly disposal.