Pioneer PRA-DW11 Bedienungsanleitung Seite 9

3. Install the accessory drive 2 frame.
÷ Insert the tabs of the accessory drive 2
frame into the square holes (4) beneath the
drive 2 opening on the front panel of the
PRV-LX1, then press the frame into the
opening. While holding the drive 2 frame
carefully to prevent it from dropping, use
the two screws (those removed in previous
step 2) to secure the drive 2 frame in place.
4. Remove the drive 2 mounting fixture.
÷ Remove the four mounting screws and take
off the drive 2 mounting fixture (the
screws will be used in step 8 to reinstall
the mounting fixture).
NOTE:
Take care to avoid touching sharp edges(*)
(do not hold by edges).
(*)
Drive 2 mounting fixture
5. Remove the protective paper from
the head dissipation sheet.
÷ Remove the protective paper from
the accessory heat sink's heat-
dissipation sheet.
NOTE:
If the heat-dissipation sheet is applied without
removing the protective paper, necessary heat
dissipation effects will not be produced, leading to
possible damage or malfunctions.
Heat-dissipation
sheet
Heat sink
NOTE 1.
NOTE 2.
Drive 2 frame
6. Install the heat sink.
÷ With the fins toward the front, align
the accessory heat sink with the
guide, then use the 2 accessory
screws (without collars) to fasten
into place.
Guide
Protective
paper
(remove)
Installation
Do not hold or press
against the cross-ribs.
Do not touch the lens
area.
Heat
sink
PRA-DW11
9
En