Maintenance - Ves Electric H-100-R Handbuch

FILTER PLACING
1. Open the lid.
2. Ensure that the filter is pressed down to the bottom of the
grooves and fits correctly then close the lid.
Note: do not leave the filter loose in the appliance. Do
not remove the filter while the appliance contains hot
water.
DRY BOIL PROTECTION AND OVERHEATING PROTECTION
The appliance has thermal automatic control thermostat for
dry boil protection and for protection against overheating, it
will operate if the appliance is switched on when containing
insufficient water level/ with no water to save the heating ele-
ment. Avoid often switch on of empty appliance or appliance
with water level below acceptable level, as this may lead to
the appliance damage.
If the appliance is switched on by accident when it is
empty, the dry boiling protection will automatically switch
it off. The appliance will cool down when filled with cold
water. Then you can use the appliance in the normal
way.

MAINTENANCE

1. Please put the appliance on a flat heat-resistant surface.
2. Pour desired amount of water into the appliance, please
make sure that the water level is between the maximum
"МАX" and minimum "МIN" marks. Wipe up the outer surface
of the appliance if it is wet.
3. Ensure the cable has been connected and 0/I switch is
at 0 position.
4