Setting-Up And Connection; Operation; Specifications - IMG STAGELINE TRITON-800 Bedienungsanleitung

professional PA application of music at me di um-sized
events and provides a maximum output power of
1200 W.
For transport, the satellite speakers and the corre-
sponding connection cables can be stowed in the sub-
woofer cabinet which is equipped with castors and
thus ideally suited for mobile applications.

4 Setting-up and Connection

1) Open the flap of the subwoofer system to take out
the satellite speakers. Make sure that the flap is
properly closed again to allow an optimum bass
reproduction during operation.
2) Place each satellite speaker on a PA speaker stand
(e. g. PAST-162SET by "img Stage Line") at a suit-
able place. It would be best to place the subwoofer
system centrically between the two satellite speak-
ers, then lock the two castors at the front.
3) As a signal source, connect an audio unit with line
output level (e. g. mixer, CD player, etc.). Connect
the two stereo channels of the signal source via an
XLR or 6.3 mm plug each to the balanced INPUT
jacks (4) or via a cable with phono connectors to
the unbalanced phono INPUT jacks (7) – R = right
channel, L = left channel.
4) At the corresponding output (3 or 6) the input signal
fed through is available. This output allows to con-
nect the input of another active speaker system if
PA application of even larger zones is required.
5) Connect the satellite speakers to the jacks SAT
SPEAKER (5) via the connection cables supplied.
Connect the plugs to the correspond ing jacks and
turn them clockwise until they lock into place. For
later removal, push the locking latch on the plug to
the rear and turn the plug counter-clockwise.
6) Finally connect the supplied mains cable to the
mains jack (13) and to a mains socket (230 V~/
50 Hz).

5 Operation

CAUTION Never adjust a very high volume. Per-
manent high volumes may damage
your hearing! The human ear will get
accustomed to high volumes which do
not seem to be that high after some
time. Therefore, do not further increase
a high volume after getting used to it.
1) Switch on the signal source connected.
2) Prior to switching on, set the control LEVEL (10) to
zero to prevent switching noise. Then switch on the
PA system with the mains switch POWER (12): The
LED AMP. ON/PROTECT (2) will show red for a
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
few seconds after switching on (protective circuit
activated, unit muted) and then change to green
(normal operation).
3) Adjust the volume with the control LEVEL (10).
From a certain volume, the LED NORM. (2) will
light up to the rhythm of the music.
If the level is too high, the LED LIMITER (2) will
light up to indicate that the integrated limiter circuit is
active. The limiter circuit serves to limit the signal
level: If the level exceeds a maximum value de fined,
it is adjusted downward to this value by the limiter cir-
cuit. If the LED LIMITER should light permanently,
turn back the volume control correspondingly.
4) Adjust the volume ratio between the subwoofer and
the satellite speakers with the control BALANCE
(11) in such a way that a natural bass reproduction
will result.
5) For stereo operation, press the button STEREO
(9). The LED ST above the button will light up. For
mono operation, unlock the button.
6) During stereo operation, the button SURROUND
(8) may be pressed to improve the surround sound.
With the button pressed, the corresponding LED
ON will light up.
7) After operation, set the control LEVEL to zero first,
then switch off the unit with the switch POWER.

6 Specifications

Max. output power: . . . . . 1200 W
RMS power
Subwoofer: . . . . . . . . . 1 × 600 W
Satellite speakers: . . . . 2 × 135 W
Speakers
Subwoofer: . . . . . . . . . 1 × 38 cm (15")
Midrange speakers: . . 2 × 25 cm (10")
Horn tweeters: . . . . . . . 2 × 2.5 cm (1")
Max. rated SPL: . . . . . . . 122 dB
Frequency range: . . . . . . 34 – 20 000 Hz
Input sensitivity
XLR / 6.3 mm jacks, bal.: 0.26 – 7 V
phono jacks, unbal.: . . 0.28 – 7 V
S / N ratio: . . . . . . . . . . . . > 80 dB
Feed-through outputs: . . XLR (bal.), phono (unbal.)
Outputs SAT SPEAKER: 8 Ω, > 150 Hz
Power supply: . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . 1860 VA
Dimensions (W × H × D)
Subwoofer: . . . . . . . . . 445 × 613 × 770 mm
Satellite speakers: . . . . 290 × 440 × 220 mm
Total weight: . . . . . . . . . . 68 kg
Subject to technical modification.
MAX
RMS
RMS
GB
7