Philips AZ 2010 Bedienungsanleitung Seite 7

DIGITAL TUNER
PROGRAMMING RADIO STATIONS
1. Tune to your desired station, following steps 1-4 under
'RADIO RECEPTION'.
™ If the frequency is already stored in the memory, the
preset number will be displayed.
2. Press PROG to activate programming.
™
flashes in the display.
PROGRAM
3. Press the PRESET 4, 3 (down, up) to allocate a preset
station number from 1 to 29.
4. Press PROG again to confirm the setting.
5. Repeat steps 1-4 to store all other presets.
• You can clear a preset number by storing another frequency
in its place.
To deactivate programming mode
If during programming you decide not to programme a station,
adjust the OFF/ TAPE•TUNER•CD slider to CD or OFF/TAPE.
Tuning to preset stations
Press the PRESET 4, 3 control (down, up) until the desired
number is shown.
CD DISPLAY INDICATION
– : CD door open
– Total track number and playing time: in stop mode
– no d1SC: when no disc inserted/ error in CD operation or
with the CD (see Troubleshooting)
– Current track number and elapsed playing time: During CD
– Elapsed playing time freezes and flashes: in PAUSE position.
– SHUFFLE/REPEAT (ALL) modes: when the respective mode
– PROGRAM: programme mode active
– : appears briefly and the selected track number (1 -20)
when you programme
– FULL: programme memory full
– : when you cancel a CD programme
– : you press PROG but no track has been selected
playback.
is activated
AZ 2010 /00
page
CD PLAYER
TUNER
FM STEREO
CD
PROGRAM
SHUFFLE
REPEAT ALL
CD
PROGRAM
CD
7
7