Maintenance; Decalcification; Cleaning Of Surfaces; See Cleaning Instructions Manual Attached - Teuco SAUNA COMFORT 2005 Bedienungsanleitung

DECALCIFICATION

Whenever the message DECA blinks in the display, this means that the system requires decalcification.
In practice, three more sauna sessions are possible, then further operation of the system will be prevented
automatically; to restore normal operation, run the decalcification cycle.
To activate the decalcification function, proceed as follows:
- remove the cap from the equipped shower column;
- pour in 0,5 l. of descaling liquid (supplied by Teuco) ;
- replace the cap;
- press the " L ", " M " and "ALARM" buttons simultaneously;
this will start the decalcification cycle (the 0/I Led blinks while the
operation is in progress).
The decalcification cycle consists in the following steps:
- boiler switches on;
- system drains completely;
- system fills to maximum stable level and drains again, twice in
succession;
- boiler fills and switches on, heats the water and empties again,
twice in succession.
The cycle takes about 3 hours.
The cycle should be run preferably during night hours, or at least
when the sauna is not in use.
The cabin can still be used with the shower or multifunctions while
the decalcification cycle is running.

CLEANING OF SURFACES

See CLEANING INSTRUCTIONS manual attached.

COMFORT

MAINTENANCE

GB
17